Panasonic KX-TGA271B Expandable Cordless Handset Instruction Manual
- June 17, 2024
- Panasonic
Table of Contents
2.4GHz Expandable Cordless Handset
Model No. KX-TGA271B/KX-TGA271V/KX-TGA271W
Installation Manual
KX-TGA271B Expandable Cordless Handset
PLEASE READ BEFORE USE AND SAVE.
This handset is an accessory cordless handset, for use with Panasonic base
units KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740/KX-TG2750/KX-TG2770/KX-FPG381.
This installation manual only describes the steps necessary to start up the
handset.
Please read the KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740/KX-TG2750/ KX-TG2770
/KX-FPG381 operating instructions for further details.
Accessories (included) For extra orders, call
1-800-332-5368.
Charger Unit ……………………………..one
Charger Order No. PQLV30014XB (Black)
PQLV30014ZW (White)
AC Adaptor Order No. KX-TCA1-G (KX-TCA1)
Handset Cover …………………………..one
Order No. PQKK10130Y3 (Black)
PQKK10130Y2 (Violet)
PQKK10130Y1 (White)
Battery ………………………….one
Order No. N4HHGMB00001 or N4HHGMB00005 (HHR-P103)
Belt Clip ………………………..one
Order No. PQKE10349Z2 (Black)
PQKE10349Z1 (White)
Installation
Connecting the Charger unit
-
USE ONLY WITH
Panasonic AC ADAPTOR KX-TCA1
(Order No. KX-TCA1-G). -
The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)
-
Installing the battery
Insert the battery into the handset as shown, matching the correct polarity
(1).
Press the battery down until it places into the compartment (2). Close the
cover.
For assistance, please call:
1-800-211-PANA(7262)
PQQX13372XB-BM S0402-5053
Charging the battery
Place the handset on the charger and charge for about 15 hours before initial
use.
-
The CHARGE indicator lights, a beep sounds and “Charging” will be displayed.
-
Recharge the battery when:
– “Recharge battery” is displayed,
– “ ” flashes on the display, or
– the handset beeps intermittently while it is in use. -
If the battery has been discharged, the handset will display “Charge for 15HRS” and “ ” when you place the handset on the charger. The handset will not work. Keep charging.
Handset battery information
After your Panasonic battery is fully charged:
| Operation | Operating time |
|---|---|
| While in use (TALK) | Up to 3.5 hours |
| While not in use (Standby) | Up to 7 days |
| While using the Reception Booster feature | Up to 2.7 hours |
When using the 2-Way Radio mode with the battery fully charged:
| Operation | Operating time |
|---|---|
| While in use (TALK) | Up to 3.5 hours |
| While not in use (Standby) | Up to 9 hours |
- Clean the charge contacts of the handset and the charger with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or high humidity. Otherwise the battery may not charge properly.
Belt Clip
You can hang the handset on your belt or pocket using the belt clip.
To attach the belt clip To remove the belt clip
While pressing the top of the clip ( A ), pull the right edge in the direction
of the arrow (B ).
Registration
This cordless handset must be registered to a KX-TG2700/KX-TG2720/ KX-TG2730
/KX-TG2740/KX-TG2750/KX-TG2770/KX-FPG381 base unit.
The handset will be assigned the extension number at registration.
Only one handset can be registered at a time.
Make sure the base unit and the other handsets are not being used.
Registration must be completed within 1 minute.
- The illustration of the base unit is the KX-TG2730.
The handset display shows the instructions as shown on the right.
-
Base unit: Press (MUTE).
• The MUTE indicator light flashes.
• On the KX-FPG381, “HS REGISTRATION” is displayed. -
Handset:
1. Press the right soft key ( OK ).
2. Wait until a long beep sounds and the display shows the registered number. The registration will be then complete.
- The registered number “[1]” to “[8]” is shown on the top right of the display.
- You can stop registration by pressing (OFF) on the handset and pressing (MUTE) on the base unit.
For assistance, please call: 1-800-211-PANA(7262)
To cancel the handset registration, please see the KX-TG2700/KX-TG2720/ KX-
TG2730/KX-TG2740/KX-TG2750/KX-TG2770/KX-FPG381 Operating Instructions.
Optional Headset
Plugging an optional headset into the handset allows a hands-free phone
conversation. Please use only a Panasonic KX-TCA60/KX-TCA86/KX-TCA88/ KX-TCA91
/KX-TCA92/KX-TCA98 headset.
To order, call the accessories telephone number on page 1.
Connecting the headset
Open the headset jack cover, and connect the headset to the headset jack as
shown.
- The illustration of the headset is the KX-TCA88.
Wall Mounting
The charger can be wall mounted. Connect the AC adaptor. Install screws using
the wall template below. Mount the charger (1). Slide it down (2) then slide
down to the right ( 3 ) until it is secured.
FCC and Other Information
When programming emergency numbers and/or making test calls to emergency numbers:
- Remain on the line and briefly explain to the dispatcher the reason for the call before hanging up.
- Perform such activities in the off-peak hours, such as early morning hours or late evenings.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Privacy of communications may not be ensured when using this phone.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this device.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Operating near 2.4GHz electrical appliances may cause interference. Move away
from the electrical appliances.
CAUTION:
To comply with FCC RF exposure requirements, the handset should be carried
with the specific belt-clip provided for the handset to ensure compliance.
Other non-tested beltclips or similar body-worn accessories may not comply,
therefore, should be avoided.
This equipment is hearing aid compatible as defined by the FCC in 47 CFR
Section 68.316.
When you hold the phone to your ear, noise might be heard in your Hearing Aid.
Some Hearing Aids are not adequately shielded from external RF (radio
frequency) energy. If noise occurs, use an optional headset accessory or the
speakerphone option (if applicable) when using this phone. Consult with your
audiologist or Hearing Aid manufacturer about the availability of Hearing Aids
which provide adequate shielding to RF energy commonly emitted by digital
devices.
For assistance, please call: 1-800-211-PANA(7262)
CAUTION:
To reduce the risk of fire or injury to persons, read and follow these
instructions.
- Use only the battery(ies) specified.
- Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste management codes for special disposal instructions.
- Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
- Exercise care in handling batteries in order not to short the battery to conductive materials such as rings, bracelets, and keys. The battery and/or conductor may overheat and cause burns.
- Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.
A nickel metal hydride battery that is recyclable powers the product you have
purchased. Please call 1-800-8-BATTERY for information on how to recycle this
battery. WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR ANY
TYPE OF MOISTURE.
- The AC adaptor is used as the main disconnect device, ensure that the AC outlet is located/installed near the unit and is easily accessible.
For your future reference
Serial No. ………………….
Date of purchase ……………..
(found on the bottom of the unit)
Name and address of dealer ……………….
If you need assistance with the set-up or operation,
please call 1-800-211-PANA(7262)
Panasonic World Wide Web address: http://www.panasonic.com
for customers in the USA or Puerto Rico
Panasonic’s e-mail address for customer inquiries:
consumerproducts@panasonic.com
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5, San Gabriel Industrial Park
Carolina, Puerto Rico 00985
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>