MOUNTUP MP0011 TV Mount Instruction Manual
- June 12, 2024
- MOUNTUP
Table of Contents
MU0011
INSTALLATION INSTRUCTION
Max:400x400mm/16×16″
Min:75x75mm /3×3″
If you have any questions, please contact us.
Safety Caution
Please read this instruction carefully before installation.
If you do not understand these instructions or have doubts about the safety of
the installation, assembly or use of this product, please contact us.
-
This product is designed for use in wood stud and solid concrete wall.
– DO NOT install into drywall alone. -
The wall must be capable of supporting five times the weight of the TV and mount combined.
-
Do not apply this product to any purpose not indicated by MOUNTUP.
-
Incorrect installation may result in product damage or body injury. MOUNTUP shall bear no responsibility for any damage or injury resulted from incorrect installation, incorrect assembly or misuse.
WARNING: This product contains small items that could be a choking hazard if swallowed.
Before starting assembly, verify all parts are included and undamaged. For parts shortage or damage, please contact us.
Must Check Before Getting Started
CAUTION: DO NOT install into drywall alone.
Installation Tools (Not Included)
Hardware Included
Step 1-1 Select TV screw diameter
Thread screws by hand into the threaded holes on the back of your TV to select which screw diameter fits your TV.
Step 1-2 Select TV screw length
When attaching brackets to the flat screen, be careful not to over tighten
screws and be sure that screws do not bottom out in the mounting
holes.
Step 1-3 Attach the bracket
CAUTION: Ensure bracket is securely fastened before moving on to the next
step.
Step 2A Wall plate installation (wood stud)
Locate your studs. Verify and mark the center of the stud by finding the stud edges using an awl, a thin nail, or an edge-to-edge stud finder.
Position the wall plate 01 at your desired height and line up the holes with your stud center line. Level the wall plate and mark the pilot hole locations.
Drill pilot holes using a 7/32 in. (5.5mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 2 3/4 in (70 mm). Be
sure to drill into the center of the stud.
2A-4
Install wall plate 01 using lag bolts A.
Tighten the lag bolts A until they are pulled firmly against the wall plate
Step 2B Wall plate installation (concrete or brick)
Position the wall plate 01 at your desired height, level the wall plate and mark the pilot hole locations x3.
2B-3
Step 3 Lift and hang TV with brackets onto wall bracket
Adjustments
Tool-free Tilting Adjustment
Leveling adjustment (-3°/+3°)
If needed, TV can be leveled ±3 degrees via adjusting the 4 nuts with the open-end wrench.
Product dimensions:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>