Skull Co 1689063131 Gaming Screen Protector Instructions
- June 12, 2024
- Skull Co
Table of Contents
Skull Co 1689063131 Gaming Screen Protector
Installation
-
Please read all steps before you start.
- Put your console on a flat surface.
-
DO NOT PEEL OFF THE MASK YET.
Place the screen protector on the screen to confirm the spacing around all sides is equal. -
Use the wet wipe to clean the screen and dry the screen with the dry wipe.
-
Use dust tape to remove the residual specks.
-
Peel off two-thirds of the back mask and hold the protector as shown in the picture. To avoid dust adhering to the protector, please work as quickly as possible.
-
Stabilize the protector with one hand as shown in the picture, and align it with the edges of the screen. If the screen protector is askew, you can remove it and start again.
-
Remove the back mask when each edge is straight. The screen protector will then affix itself to the screen.
-
You can tap the center of the screen protector to help it affix to the screen. The air will be expelled towards the edges.
- DO NOT FIT THE PROTECTOR FROM THE EDGES. The air will be trapped inside and becomes bubbles.
-
Lastly, squeeze any trapped air bubbles toward the edges.
-
PLEASE DO NOT WORRY IF THERE ARE SOME SMALL BUBBLES THAT CAN NOT BE EXPELLED. THE BUBBLES USUALLY DISAPPEAR WITHIN 48 HOURS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>