NEHEME NH760 6 Axis Gyro Drone User Manual
- June 15, 2024
- NEHEME
Table of Contents
NEHEME NH760 6 Axis Gyro Drone
FORBIDDEN: Special design for indoors & outdoors, keep it far from
obstacles This product is suitable for indoors (the wind grade should be no
more than 4), please choose a place without obstacles, and keep a distance
from the crowd and pets. Don’t play it under unsafety, for instance, heat
source, wire or electric power source, and avoid being damaged by collision
landing, entanglement, electric shock or causing unnecessary loss of lives and
property.
WARNING: Obtain the assistance of an experienced pilot The products are
suitable for more than 14 years old, at the beginning it will have certain
difficulties in learning, suggestions or guidance by the experienced is needed
before playing.
DRONE
Propeller guards Installation
Unfold the drone, and then push the propeller shields upwards from below.
CHANGE BLADES
- Replacing damaged blades: Your set comes with 2 replacement rotors, A and B type.
- You will see the ‘A’ and ‘B’ letters typed on the blade. Put the rotor on the motor accordingly.
- If the replacement of wind blades is incorrect, the drone will not be able to control it.
IMPORTANT NOTES
- This product is NOT A TOY. It may cause damage by used incorrectly.
- Please use this it following this instruction. And do not disassemble this product by yourself.
- This flying model requires practice before you use it.
- Please follow this instruction and practice patiently or guided by the experienced pilot.
- Otherwise, the manufacturer shall not be responsible for any damage to the product or injury to any person.
SAFETY NOTES
Fly only in safe areas away from other people. Do not operate an R/C drone
within the vicinity of crowds. R/C drone is prone to accidents, failures, or
damage and injury because of operation error, or radio interference. Pilots
should be responsible for their behaviors for possible damage or injury that
may occur during the operation or cause R/C drone models to break.
TRANSMITTER
NOTE: The right arm of the transmitter is Power ON / OFF. By extending the right arm, the controller will automatically Power ON and make a beep sound. The Power Indicator will turn ON. Also, closing the right controller arm will turn off the controller.
ASSEMBLED REMOTE CONTROLLER
- Open the battery cover on the back of the remote controller.
- Insert 2*AAA batteries under the instructions on the battery box.
- (Battery should be purchased separately, old and new or different types of batteries shouldn’t be mixed.)
BATTERY INSTRUCTIONS
-
RECHARGING: While the battery is charging, the LED light on the USB is on; When fully charged, the LED light goes off.
The whole recharge time will be around 60 minutes. -
SAFETY: Different types of batteries or old and new batteries should not be mixed.
- Only use the provided charger line to charge.
- Follow the polarity correctly installed batteries power and ensure terminals shall not be short-circuited.
- Rechargeable batteries can only be charged under the supervision of an adult.
- Do not use rechargeable battery overcharging.
- Exhausted batteries should be taken out of the remote control.
- Use batteries according to the Environmental Protection Agency.
OPERATION AND CONTROL
READY TO FLY: Make sure the propeller is installed correctly and fastened
- Turn the right remote control leg support to turn on the remote control.
- Push the throttle lever up and down. The controller connects to the drone.
TAKEOFF METHOD 1
- Put the drone at a level position, and push two levers down to 45 degrees for 2-3s as the picture shows, the light on the drone keeps flashing, and after 2-3s, the light remains on.
- Push two rockers at the same time as shown in Figure for 2-3s to unlock the drone.
- Slowly push the throttle stick to take off the drone.
TAKEOFF METHOD 2
- Place the drone at a level position, push two levers down to 45-degree for 2-3s as the picture shows, the light on the drone keeps flashing, and after 2-3s, the light remains on.
- Press the one key taking off button, the drone starts to take off.
LANDING METHOD 1
- Press the throttle down slowly and hold it on the button for 2-3 seconds until the blade stop spinning.
LANDING METHOD 2
- Press the One Key Landing button, the drone will land slowly.
EMERGENCY LANDING
- In the case of an emergency, press the Emergency Stop button, and the drone will fall down immediately. This is only for urgent situations using.
FLYING CONTROLLED AND FINE-TUNING
Headless Mode: Press the button on the controller, and you will hear beep
sounds, and then you get into compass mode. When the drone is taking off, the
direction, in which the drone is headed, will be the front side. The
left/right/backside are also be recognized by geographic direction. During
headless mode, the LED light will be flashing all the time.
One Key Come Back: When the drone is taking off, we put the drone on the
floor, and the backside points to the player. During flying, we press one key
to come back, the drone will fly back to the player. Pls kindly make sure
there’s enough distance when you are using one key comeback function.
Otherwise, it might hurt the player.
3D Action Operation
Fly your drone in a height of more than 3 meters, and press the 3D Roll button
on the top right of the controller. Then immediately push the right controller
stick to the left/right/ forward/backward side to flip your drone.
CAMERA ADJUSTMENT
- The angle of the camera could be adjusted 45° up and down by hand before the flight.
APP OPERATING GUIDE
- Install mobile phone client
- Please scan the corresponding QR code to download APP
Add a device
- Turn on the product power switch
- Enter the phone “settings” and open WIFI
- Find the WIFI (WIFI_1080P / WIFI_4K / FLOW4K****) from the WIFI list, click on the connection directly without using the password
- Open APP, click the star icon to enter the real-time interface
- Click on the “Album” icon to enter the real-time interface
Operating instructions
From the icon meaning of each operating and player interface, please see
below.
COMMON PROBLEM AND SOLUTION INSTRUCTION
PRECAUTION
- The remote-controlled distance will be shortened when the power(drone or transmitter) is insufficient.
- It is difficult to take off or fly high when the power of the drone is insufficient.
- When the drone is damaged, please stop operating and repair it in time, or it may lead to injury.
- If you don’t use the transmitter for a long time, please remove the batteries to avoid battery leakage.
- Do not drop the transmitter from a high altitude or crash it badly, otherwise, it will shorten its use life.
ACCESSORIES
CONTACT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>