marta MT-KP1539A Countertop Blender User Manual

: June 9, 2024
: MARTA

Table of Contents

MT-KP1539A Countertop Blender
BEFORE THE FIRST USE
INSTRUCTION FOR USE
CLEANING AND MAINTENANCE
SPECIFICATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

COUNTERTOP BLENDER
MT-KP1539A
User manual

MT-KP1539A Countertop Blender

CAUTION

Read this manual carefully before using the appliance and save it for future reference.
Before the first use, check the device specifications and the power supply in your network.
It is not intended for industrial use.
For indoor use only. Use only for domestic purposes according to the instruction manual.
Keep the power cord away from sharp edges and hot surfaces.
Do not pull the cord. Always take the socket. Do not reel the cord around the device housing.
Never attempt to frame and repair the appliance by yourself. If you meet problems, please contact the nearest customer service center.
Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.
To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Be cautious when using blade.
Every time after use, make sure the appliance is turned off, the blades stopped completely. Only then open the lid.
Do not overload the appliance. The appliance is designed for processing relatively small quantities of food and maximum quantities given in the table should not be exceeded.
Never blend hot liquids!
Maximum time of continuous operation – no more than 1 minute with an interval for at least 5 minutes.
Do not use the device if the cord is damaged.
Do not use the device if the cup is empty.
Do not leave the device unattended.
Always disconnect the device from power supply if you do niot use it and before cleaning.

BEFORE THE FIRST USE

Please unpack your appliance and remove all packing materials
Clean the motor unit with dump cloth, wash blades and jar with soapy water, rinse and dry.
Do not immerse motor unit into water.

INSTRUCTION FOR USE

Place the device on a flat steady surface.
Load the ingredients into the jar. Cut big pieces into smaller ones with size of 2-3 cm.
Connect the blade unit to the jar.
Install the jar with blade unit onto motor unit by turning it clockwise.
Caution: blender cannot be used for crushing ice and mixing hot ingredients! This can cause damage of the device.
Insert the plug into power supply. Select the appropriate blending speed.

NOTE: The switch does not permanently engage in the ‘P’ setting. You have to hold the switch in the ‘P’ setting or turn it repeatedly into the ‘P’ setting.

Before opening lid wait until blade fully stops. Before removing bottle from the motor unit unplug the device from the power source.
Disconnect bottle from the blade unit.

CAUTION: For most kinds of food, it is advisable to switch on the device a few times in succession and then to continue operating until the required degree of fineness has been achieved.
Do not overload the appliance by putting in too much food and do not operate continuously for more than one minute.

CLEANING AND MAINTENANCE

Unplug the appliance from the power supply.
Wipe the motor outside with a damp cloth.
Wash jar, blades and lid right after use with warm soapy water and wipe it with dry cloth.
Do not use aggressive and abrasive agents for cleaning

CAUTION: The blades are sharp and therefore dangerous. Handle with caution.
STORAGE

Before storing, dry thoroughly the container, container lid, cutting blade.
Store the appliance in a cool, dry place.

SPECIFICATION

Power supply
230 V ~ 50 Hz
WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.)
Production date is available in the serial number located on the identification sticker on the gift box and/or on sticker on the device. The serial number consists of 13 characters, the 4th and 5th characters
indicate the month, the 6th and 7th indicate the year of device production.
Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice. Please check when purchasing device.
Current information about service centers is available on the website http://multimarta.com
Producer:
Cosmos Far View International Limited
Room 701, 16 apt, Lane 165, Rainbow North Street , Ningbo, China
Made in China