HAT COLLECTIVE FLEXMOUNT 8111 Mount Kit Instruction Manual
- June 4, 2024
- HAT COLLECTIVE
Table of Contents
HAT COLLECTIVE FLEXMOUNT 8111 Mount Kit
Installation Instructions
FLEX MOUNT 8111
Desk Clamp
Thru-Desk
- 8111-CUP
- 8111-THRU
Wall Mount
Reverse Wall Mount
8111-WALL
Grommet Hole
Side Bolt
Parts List
MODEL 7000
Installation Instructions
Parts List
OPTIONAL SPACER KITS
In some cases, the mounting surface on your monitor may be recessed further
than permitted by VESA® standards. As a result, a spacer kit may be required.
25″ Spacer Hardware Kit
- (4) .25″ Spacers
- (4) M4 x 18mm Phillips Pan Head Screws
- Order # P404923-B
5″ Spacer Hardware Kit
- (4) .5″ Spacers
- (4) M4 x 25mm Phillips Pan Head Screws
- Order # P404923-C
How do I counterbalance my arm?
IMPORTANT!
- • Monitor must be on the arm
• Arm must be in mount
Press the arm down to approximately parallel with the desk prior to turning
the strength adjustment screw. 
If the arm drifts upward, turn the adjustment screw clockwise.
If the arm drifts downward, turn the adjustment screw counter-clockwise.
Depending on the weight of your monitor, you may have to make 15-20 turns
.
In some instances
An additional counterbalance adjustment may be needed to allow the arm’s
instant height adjustment function to work properly. If your arm is not
staying in position after performing step 1, tighten the adjustment screw as
shown.
Tighten the adjustment screw.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>