mestic MWC-100 Smart Adventure Kettle Instruction Manual

mystic MWC-100 Smart Adventure Kettle

Product Information

• Capacity: 0.8 L
• Power: 850 W
• Voltage: AC 230 V
• Weight: 0.7 kg

Product Usage Instructions

1. Fill the kettle with water. Do not overfill. Use the water level indicator.
2. Place the kettle on the base.
3. Check whether the electrical voltage which you intend to use is the same as that of the kettles. Details can be found on the label on the base of the kettle.
4. Only connect the kettle to a properly installed 230V 50/60Hz socket.
5. Switch the kettle to position ‘1’. The control lamp on the water indicator shows that the water is boiling.
6. After boiling, the kettle switches off automatically. Disconnect the kettle from the mains electricity supply. Do not open the lid when pouring.
7. If the kettle is overfilled, boiling water may be ejected.
8. The kettle is only to be used with the stand provided.

mestic MWC-100 Smart Adventure Kettle

1. Vul de ketel met water. Niet te vol.
2. Zet de ketel op de voedingsunit.
3. Controleer of het voltage dat u gaat gebruiken overeenkomt met het voltage van het apparaat.
4. Verbind de ketel alleen met een goed gemonteerd 220-240V 50/60 Hz stopcontact.
5. Zet de waterkoker op positie 1. Als het controle lampje gaat branden, kookt het water.
6. Als het water kookt, gaat het apparaat automatisch uit. Verwijder dan de stekker uit het stopcontact. Open de deksel niet als u het water schenkt.
7. Als de waterkoker te vol zit, kan er water uitspatten, wanneer het kookt.
8. De waterkoker mag alleen gebruikt worden op de bijbehorende standaard.

Product Usage Instructions (Deutsch):

1. Informationen hierzu finden Sie auf dem Etikett am Boden des Wasserkochers.
2. Wasserkocher nur mit einer korrekt installierten 220-240V 50/60Hz Steckdose verbinden.
3. Schalten Sie den Wasserkocher auf Position 1. Die Kontrolleuchte an der Wasseranzeige zeigt an, dass das Wasser kocht.
4. Der Wasserkocher schaltet sich bei kochendem Wasser automatisch ab. Trennen Sie den Wasserkocher von der Stromversorgung.

General Safety Instructions

• Before commissioning this kettle, please read the instruction manual carefully.
• Please keep the instruction manual, guarantee certificate, the sales receipt and if possible, the carton with the inner packaging.
• This kettle is intended exclusively for private and not for commercial use.
• Switch off the kettle and remove the plug from the socket when the kettle is not in use. When you disconnect the power cord of the kettle, grasp and pull the plug, not the cord/cable.
• Switch off the kettle before cleaning the kettle.
• Keep the kettle out of the reach of children. Do not leave children unsupervised with the kettle.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Test the kettle and the cord/cable regularly for damage. Check that the kettle is operating properly. If there is damage of any kind or if the kettle is not operating properly, stop using the kettle and unplug it immediately.
• Do not attempt to repair the kettle yourself, only authorized and qualified personnel may repair this kettle.
• Keep the kettle and cord/cable away from heat, direct sunlight, water, moisture, sharp edges, and so on.
• Use only original accessories, do not connect incompatible products.
• Do not use the kettle outdoors.
• The base and exterior of the kettle are not water-resistant, keep it dry at all times.
• Under no circumstances must the kettle be placed in water or any liquid or come in contact with liquid. Do not handle the kettle with wet or moist hands. If the kettle becomes wet or moist, remove the main plug from the socket immediately.
• DO NOT touch the contents of the kettle.
• Use the kettle only for its intended purpose.
• The kettle is only to be used with the stand provided.
• If the supply cord is damaged, please replace by the service center or the person designated by the manufacturer or a qualified person to avoid electric shock.

Special Safety Instructions for the Kettle

• Use only cold water when filling the device.
• The water level must be between the MAX. and MIN. marks.
• Switch the kettle off before removing it from the base.
• Always ensure that the lid is tightly closed.
• The base and exterior of the kettle must not become wet.
• Kettle body used must match with the kettle base.

First Use of the Kettle

• Before using the kettle for the first time, fill the kettle with cold water and boil it twice without any additives.
  1. Fill the kettle with water. Do not overfill. Use the water level indicator.
  2. Place the kettle on the base.
  3. Check whether the electrical voltage which you intend to use is the same as that of the kettle’s. Details can be found on the label on the base of the kettle.
  4. Only connect the kettle to a properly installed 230V 50/60Hz socket.
  5. Switch the kettle to position ‘1’. The control lamp on the water indicator shows that the water is boiling.
  6. After boiling, the kettle switches off automatically. Disconnect the kettle from the mains electricity supply. Do not open the lid when pouring.
  7. If the kettle is overfilled, boiling water may be ejected.
  8. The kettle is only to be used with the stand provided.

Cleaning

Always remove the plug from the mains supply before cleaning the machine! The exterior of the machine should be cleaned, if necessary, with slightly damp cloth additives.

Recycling

This product bears the selective sorting symbol for waste electrical and electronic equipment This means that this product must be handled pursuant to European Directive (2012/19/EU) in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human heath due to the presence of hazardous substances.

Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MWC-100, applies all basic requirements and other relevant regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive (2014/35/EU). If you require a full declaration of conformity, you can contact the address listed on the backside of this manual

Importer:
Gimeg Nederland B.V.
Atoomweg 99, 3542 AA
Utrecht The Netherlands

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>