mestic ME-80 Espresso Machine Instruction Manual
- June 12, 2024
- mestic
Table of Contents
mestic ME-80 Espresso Machine
Product Information
-
Product Name: Espresso machine ME-80
-
Power: 1000 W
-
Voltage: 220-240 V
-
Weight: 2.3 kg
-
Compatible Cups: Only compatible with aluminum cups
Product Usage Instructions
Important Safety Instructions:
- Always follow general safety instructions when using electrical appliances to reduce the risk of fire, electric shock, and personal injury.
Parts
- Buttons
- Control lives
- Capsule compartment
- Coffee nozzle
- Capsule container
- Coffee cup tray
- Coffee cup plate
- Drip tray
- Housing
- Power cord
- Removable water tank and lid
Initial Setup
- Check for missing accessories and ensure the machine is not damaged.
- Clean the inner parts of the machine.
- Follow the steps below to install and operate the machine:
Installation and Operation
- Rinse the water tank and fill it with water.
- Install the water tank, drip tray, and capsule holder in the correct positions on the machine.
- Plug in the espresso machine, and both coffee buttons will blink three times.
- Press any coffee button to start heating while the flashing lights continue.
- When the buttons stop blinking and remain lit continuously, the machine is ready for use.
- Press and hold both coffee buttons simultaneously to turn off the machine.
Brewing Coffee
- Open the water reservoir lid and fill it with the desired amount of water. Repeat steps 3 to 5 from the installation and operation section.
- Open the control lever and place a capsule inside, then close the control lever.
- Only use aluminum cups.
- Open the control lever after extraction is complete. The capsule will be automatically ejected into the used capsule container.
_ Note: It is recommended to clean the machine regularly, approximately every three months or after using around 200 capsules. _For more detailed information and compliance declaration, please refer to the user manual provided by Gimeg Nederland B.V.
Important safety notice
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electrical shock and/or personal injury.
- Buttons
- Operating lever
- Capsule compartment
- Coffee nozzle
- Used capsule compartment
- Espresso coffee cup tray
- Coffee cup tray
- Drip tray
- Body
- Power cord
- Removable water tank & lid
Your coffee maker
Please study these operating instructions before using the coffee maker. By
following them carefully, and by paying special attention to the safety
instructions, you will ensure that this coffee maker will go on making perfect
coffee for years to come.
- Read all instructions.
- Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the coffee maker.
- Do not put the appliance, the power cable or the plug in water or any other liquid.
- Unplug from outlet when not in use and before cleaning.
- Do not operate any appliance with a damaged cord or plug, or in abnormal state. If the main cord is damaged, it must be replaced by the manufacturer, the nearest service agent or a similarly qualified person.
- The use of accessory is not recommended by the appliance manufacturer. It may result infire, electric shock and/or personal injury.
- Do not let cord hang over edge of table or counter, or touch hot surface.
- To disconnect, remove plug from wall outlet. Always hold the plug; never pull the cord.
- Do not use the appliance for other than its intended use and place it in a dry environment.
- Do not leave the coffee maker unattended while it is operating; the appliance must not be operated by children.
- Be careful not to get burned by the steam.
- Do not touch the hot surface. Use handles or knobs only.
- Never use your coffee maker without water in it.
- Make the appliance stand on a table or a flat surface.
- Do not use outdoors.
- Save these instructions.
- This appliance is not intend for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
Using your coffee machine for the first time.
Confirm whether any accessories are missing and the appliance is not damaged.
Then clean the inner parts, then install and operate the machine as per the
following steps.
- Rinse the water tank then filling with water.
- Install the water tank, drip tray and capsule container in proper position on the machine.
- Turn the machine ON by connecting the plug into the mains, both coffee buttons blink three times.
- Press any coffee button to start heating up.
- When the buttons stop blinking and show steady light, The machine is ready for use.
- Press and hold the two coffee buttons simultaneously to turn OFF the machine.
Using Coffee machine:
Before making any coffee, make sure to rinse your machine by
- Placing a container under the coffee extraction nozzle.
- Closing the operating lever and pressing the Lungo button to rinse the machine.
- Repeat this three times.
Making coffee
Open the water reservoir lid and fill the water tank with the desired amount
of water. You repeat the previous steps from step 3 to 5.
-
Turn the machine ON by connecting the plug into mains, both coffee buttons blink for three times .
-
Press any coffee button to start heating up.
-
When buttons stop blinking and shows steady light, The machine is ready for use.
-
Place a cup.
-
Open the operating lever, insert a capsule and then closed.
only compatible with: aluminum cups -
Press one of the two coffee buttons ( desired amount) while the light is blinking. The machine will start making your cup of coffee
-
Open the operating lever after extraction stopped. The capsule will be automaticly ejected and drop into the used capsule container.
- The pre-defined factory volume for Espresso coffee (20-25ml) / Lungo coffee (40-50ml)
- Extraction will stop automatically or press the selected coffee button to stop ahead
Energy saving mode
- Automatic Stand-by mode: the machine will turn into stand-by mode automatically after 5 minutes of non use. The boiler turned off and the external surface of the machine cools down. All button indicator lights on the control panel go out.
- When user press any coffee button again, the appliance leaves from standby mode, restart heating up process until “Ready to use”.
Warning
If both coffee buttons flash alternately (see illustration). Turn the device
off, wait 2 minutes, and then turn it on again to check if the problem is
resolved. Otherwise, contact the authorized representative for examination,
repair or adjustment.
Personal settings
The control panel can also be used to personalize the different extracted
coffee capacity. The predefined factory volume for the small cup is (20-25 ml)
/ and for the large cup is (40-50 ml).
- Check whether there is drinking water in the water tank, check that the machine is ON. Wait until the buttons on the control panel are “Ready for use”.
- Then press and hold any coffee button for 3 seconds until the coffee comes out, then release the button (see figure). Once the coffee has reached the desired capacity, press the selected coffee button again and the operation is complete.
- The machine remembers the current personal setting and saves the same coffee quantity for the next time unless new programming is defined.
Reset to factory settings
- Make sure the machine is switched off without mains power.
- Press both coffee buttons together for at least 3 seconds and connect the machine to the mains at the same time.
Cleaning and maintenance
- Remove the plug from the socket
- Never immerse the appliance in water.
- Only clean the device with a dry cloth.
- Empty the drip tray and used capsule container after each use.
- Clean the coffee nozzle and the inside of the machine regularly with a damp cloth.
- Do not use a strong or abrasive solvent, sponge or cream cleaner. Do not put in the dishwasher.
- For your coffee machine to work efficiently, you must regularly clean the scale deposits produced by the water. We recommend that you use the appliance every three months or after approx. 200 capsules.
Recycling
This product bears the selective sorting symbol for waste electrical and
electronic equipment This means that this product must be handled pursuant to
European Directive 2012/19/EU in order to be recycled or dismantled to
minimize its impact on the environment. For further information, please
contact your local or regional authorities. Electronic products not included
in the selective sorting process are potentially dangerous for the environment
and human health due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device ME-80, applies all basic
requirements and other relevant regulations listed in the European directive
for electromagnetic compatibility (2014/30/EU) and low voltage directive
(2014/35/EU). If you require a full declaration of conformity, you can contact
the address listed on the backside of this manual
CONTACT
- Importer:
- Gimeg Nederland B.V.
- Atoomweg 99, 3542 AA Utrecht
- The Netherlands
ONLY COMPATIBLE WITH ALUMINUM CUPS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>