strex SP181 Telescopisch Doucherek RVS Instruction Manual
- June 12, 2024
- STREX
Table of Contents
SP181 Telescopisch Doucherek RVS
Instruction Manual
SP181 Telescopisch Doucherek RVS
Strex Instruction Manual
SP181/SP241
Please refer to the backside of this booklet to find out how many and which
rods (S) you need for your perfect height. Place the silicone foot (F1) on
the lower end of the first rod (S) and put also your other rods on top of it.
Put
the silicone ring (R) over the rod (S) and position it at the height at which
you want the basket (K) at. Place the basket (K) over the ring (R). Repeat
this with the other baskets. Baskets can only be attached to S-rods, not
E-rods.
Push the cap (C1) over the top of the rod (S3). This
rod (S3) is always the uppermost S-rod. Insert the rod (E1) into the rod (S3)
and rotate it until it is firmly seated in the rod (S3). To change the height
afterwards, you can tighten the rod (E1) to the desired height. Hereby, the
notch on the rod (E1) should not be visible, respectively not be outside the
rod (S3).
Insert the spiral spring (E2) into the rod (E1), if
it is not already inside. Put the cap (C2) over the top of the rod (E1). Now
insert the rod (E3) into the rod (E1). The height can also be finely adjusted
by pressing on the spiral spring (E2). You can achieve the best grip by
tensioning the spiral spring (E2) to a depth of approx. 5cm. 
You
can now place the silicone head (F2) on the top of the rod (E3) and mount the
rack. The easiest way is to first position the upper end of the rod on the
ceiling and then, by pressing on the spiral spring, place the lower end of the
rod on the floor.
Bekijk hier de montagevideo:www.support.strex.nl/files/sp181/montage.mp4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>