baby lock BLCS-GP General Purpose Foot Instructions
- June 12, 2024
- Baby Lock
Table of Contents
baby lock BLCS-GP General Purpose Foot
Product Information
The Baby Lock Serger Accessories include the General Purpose Foot (BLCS-GP). This foot is designed for use with the Baby Lock Cover Stitch machine. It features raised markings on the toe of the foot, which serve as seam line guides. These markings indicate the needle positions, helping to guide fabric for accurate seaming.
Product Usage Instructions
Release the General Purpose Foot
- Raise the presser foot lever.
- Lower the cutting blade.
- Raise the needles to the highest position.
- Push the presser foot release lever located at the back of the presser foot holder.
- Carefully turn the presser foot clockwise 90 degrees.
- Slide the presser foot to the rear to remove.
Replace the General Purpose Foot
- Raise the presser foot lever.
- Lower the cutting blade.
- Raise the needles to the highest position.
- Slide the foot from the left to the right.
- Align the bar of the foot with the groove in the holder.
- Lower the presser foot lever to snap into place.
Inserting Tapes – Cover Stitch
The front of the presser foot has a tape sewing slot. This slot can be used
with narrow, wide, or triple cover stitches. To insert decorative tape,
ribbon, or elastic:
- Insert the ribbon or elastic into the slot.
- Guide the ribbon or elastic down under the foot towards the needles.
- Serge with the cover stitch to secure the ribbon or elastic to the fabric.
For further assistance, contact Baby Lock customer support at 800-422-2952 or visit www.babylock.com.
Product Instructions
The Baby Lock Cover Stitch machine has the convenience of a snapon presser foot. The raised markings on the toe of the foot are seam line guides. They indicate the needle positions to help guide your fabric for accurate seaming.
To Release:
- Raise the presser foot lever.
- Lower the cutting blade.
- Raise the needles to the highest position.
- Push the presser foot release lever located at the back of the presser foot holder.
- Carefully turn the presser foot clockwise 90 degrees.
- Slide the presser foot to the rear to remove.
To Replace:
- Raise the presser foot lever.
- Lower the cutting blade.
- Raise the needles to the highest position.
- Slide the foot from the left to the right.
- Align the bar of the foot with the groove in the holder.
- Lower the presser foot lever to snap into place.
Inserting Tapes – Cover Stitch
The front of the presser foot has a tape sewing slot. The slot on the standard
foot can be used with the narrow, wide, or triple cover stitches.
Decorative tape, ribbon, or elastic can be inserted into the slot and serged
with the cover stitch. Insert the ribbon or elastic into the slot and down
under the foot to the needles.