ORCHARD AUDIO sk-module Starkrimson Amp Module Instructions
- June 4, 2024
- Orchard Audio
Table of Contents
ORCHARD AUDIO sk-module Starkrimson Amp
NOTES
- Due to the bridged amplifier design both speaker terminals (HL1 & HL2) are hot when the amplifier is on. o Do not connect either output to ground (GND)
- Do not power up the amp without a load or speaker connected. · Do not plug in a live power supply into the amp.
Starkrimson Instructions
To turn the amp on
- Connect speakers
- Connect Input (XLR)
- Plug-in power supply into the amp (power supply must be off)
- Turn on the power supply
To turn the amp off
- Turn off the power supply and allow at least 3 minutes for all capacitors to discharge
- Remove connections
Amplifier Output
- The amplifier outputs are HL1 and HL2.
Amplifier Input
- The amplifier input is the XLR connector
Mounting Holes
- The module has 5 mounting holes which work with either M3 or 4-40 hardware
- All mounting holes are connected to module ground
Power Supply Connection
- The power supply should be 45.6V minimum, 58.8V maximum with a minimum output power of 250W.
- Recommend Power Supply: Recom-Power RACM230-54SG (one per amp module)
- If using a power supply with more than 300W output power, it is highly recommended to put a fuse inline between the power supply and amplifier.
- The mating plug is Molex / 39-01-2060, with the following pinout:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>