Orchard Audio Starkrimson Mono Premium Audiophile Instructions

Orchard Audio Starkrimson Mono Premium Audiophile

Product Specifications

• Model: Amplifier X1000
• Power Output: 1000W
• Inputs: XLR
• Power Supply : AC 110-240V, 50/60Hz
• Dimensions (W x H x D): 17″ x 3.5″ x 10″
• Weight: 8 lbs

Product Usage Instructions

Turning the Amplifier On

1. Place the amplifier(s) close to the speaker(s) with short speaker cables.
2. Connect the speaker to the amplifier.
3. Connect the XLR input to the amplifier.
4. Ensure the power switch is in the off position (0).
5. Connect the power cord to the amplifier.
6. Turn the power switch to the on position (I).

Turning the Amplifier Off:

1. Turn the power switch to the off position (0).
2. Wait at least 15 seconds.
3. Remove any other connections if necessary.

Note: Improper power-up or power-down of the amplifier may cause damage not covered under warranty.

INSTRUCTION

Notes:

• Do not power up or operate the amplifier without speakers or a load connected.
• Due to the bridged amplifier design, both speaker terminals are hot when the amplifier is on.
  • Warning – High Voltage
  • Do not connect either speaker terminal to GND or EARTH
• The amplifier uses a universal AC input power supply and will function with all voltages between 85 and 264 VAC.
• No user-serviceable parts – tampering with the amplifier will void the warranty

For best performance place the amp(s) as close as possible to the speaker(s) and use very short speaker cables.

To Turn the Amplifier On

1. Connect speaker
2. Connect XLR input
3. Make sure the power switch is in the off position (0).
4. Connect power cord
5. Turn the power switch to the on position (I).

To Turn the Amplifier Off

1. Turn the power switch to the off position (0).
2. Wait at least 15 seconds
3. Remove other connection(s) if needed.

Improper powerup or power down of the amps may cause damage and this damage will not be covered under the warranty.

How do you like them apples?

Frequently Asked Questions

• Q: Can I use longer speaker cables with the amplifier?
  • A: For best performance, it is recommended to use very short speaker cables to minimize signal loss and interference.
• Q: What should I do if the amplifier is not turning on?
  • A: Check the power switch position, ensure all connections are secure, and verify the power source before contacting customer support.
• Q: Is it safe to leave the amplifier on standby mode for extended periods?
  • A: It is recommended to turn off the amplifier when not in use to conserve energy and prevent any potential issues.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>