Orchard Audio Starkrimson Mono Ultra Premium LPS 500W Instructions
- June 26, 2024
- Orchard Audio
Table of Contents
Orchard Audio Starkrimson Mono Ultra Premium LPS 500W
Product Information
Specifications
- Model: Amplifier X123
- Output Voltage: Up to 80V
- Revision: 1.1
Product Usage Instructions
Safety Precautions
- Ensure the amplifier is turned off before connecting or disconnecting any cables.
- Avoid touching the amplifier outputs (speaker terminals) when the amplifier is on due to the high voltage.
- Keep the amplifier away from water or moisture to prevent electrical hazards.
Connection
- Connect your audio source (e.g., music player) to the input of the amplifier using appropriate cables.
- Connect the speakers to the amplifier output terminals ensuring correct polarity (+/-).
Powering On/Off
- Turn on the amplifier by pressing the power button located on the front panel.
- To turn off the amplifier, press and hold the power button until the unit powers down completely.
Frequently Asked Questions
Q: Can I use this amplifier with headphones?
A: No, this amplifier is designed for use with speakers and not headphones.
Q: What is the recommended power supply voltage for this amplifier?
A: The recommended power supply voltage for this amplifier is 110-120V AC.
Starkrimson® Mono Ultra Premium LPS Instructions
Usage Instructions
Danger High Voltage:
The amplifier outputs (speaker terminals) can be up to 80V, do not touch while the amplifier is on.
Notes:
- Do not make or break the connections to the amplifier while it is on.
- Due to the bridged amplifier design, both speaker terminals are hot when the amplifier is on.
- Do not connect either of the speaker terminals to ground/earth ground.
- There are no user-serviceable parts, opening the amplifier will void the warranty.
To turn the amp on:
- Connect Speakers.
- Connect XLR Input.
- Plug the power cord into the amplifier.
- Turn it on by firmly pressing the switch into the ON (I) position, the switch will make a click when fully engaged.
- It may take up to 30 seconds for the amplifier to become active.
To turn the amp off:
- Turn off by pressing the switch into the OFF (0) position, the switch will make a click when fully disengaged.
- NOTE: Due to the very large capacitor bank, wait at least two (2) minutes after pressing the switch before removing any cables.
Amplifier Protection Circuits
- Thermal – If the amplifier overheats it will turn off until it is cool enough to continue operation.
- Overload – If overload occurs, the amplifier will turn off for 20 seconds and then turn back on.
- Circuit Breaker – The On/OFF switch is also a circuit breaker, in a scenario where it turns itself OFF (0), wait at least 5 minutes before turning it back on. If it turns OFF (0) a second time please contact us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>