VISUAL COMFORT KW 2521 Pertica 9 Inch Sconce Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT KW 2521 Pertica 9 Inch Sconce Instruction Manual
Assembly Instructions
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver: Slotted Screwdriver
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (C) from fixture (H) by removing screws (G) using provided screwdriver (F).
-
Connect driver (J) input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect driver (J) input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION : Do not reverse the hot and neutral connections. -
Insert driver (J) into junction box.
-
Wrap supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten.
NOTE : It is imperative that the fixture is grounded. -
Install mounting plate (C) to the junction box and secure with mounting screws (E).
-
Connect quick connectors (K1) & (K2) together.
-
Install fixture (H) to mounting plate (C) and secure with screws (G) using the provided screwdriver (F).
-
Thread shade (I) to fixture (H).
NOTE : Do not over-tighten otherwise glass shade could be damaged.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
