VISUAL COMFORT SL 5863 Linear Branched Chandelier Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
SL 5863 Linear Branched Chandelier
Instruction Manual Linear Branched Chandelier
Item # SL 5863
ASSEMBLY INSTRUCTIONS
SL 5863 Linear Branched Chandelier
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
Chain Pliers
Slip Joint Pliers
Measuring Tape
Wire Cutters
Wire Strippers
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Feed electrical wires through bottom rod (H) and connect to fixture body (J).
-
Feed electrical wires through collar ring (F), canopy (E) and top rod (G). Then connect top rod (G) to bottom rod (H).
-
Secure collar loop (C) to mounting plate (B) using pliers to tighten locknut.
-
Install mounting plate (B) to the junction box and secure with mounting screws (D).
-
Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8″.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (smooth with markings) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install canopy (E) to collar loop (C) and secure with collar ring (F).
-
Place shades (K) on top of sockets ( J ) as shown in line diagram.
NOTE: Shades are sold separately. -
Install light bulbs into the sockets.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
Not use abrasive or chemical agents. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>