VIBIA Duo Ceiling Light Installation Guide

: June 12, 2024
: VIBIA

Table of Contents

Supplied material
Technical specifications
Maintenance
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Assembly instructions
Duo
Design by Ramos & Bassols

4870 1 un.
4872 1 un.

Supplied material

Technical specifications

4870 Net Weight| 1 x LED PLATE 26W 500mA|
---|---|---
4872 Net Weight| 1 x LED PLATE 46W 500mA|

Class I. Product with an additional protection cable (grounds).
Product protected against solid object as big as or bigger than 12 mm. No protection against water.
Alternating current.
Caution
Before assembling and installing this product, carefully read the following:
– Switch of the mains before installing the lamp.
– To install on the ceiling, always choose the most adequate fixing tools for the ceiling material.
– This lamp is for indoor use only, excluding bathrooms or any type of damp surface.
– We recommend reading the manual before in stallaing the lamp. Keep this instructions for future reference.
– Do not disassemble, modify or try to repair this fitting. In order to get technical assistance contact VIBIA. Any change or modification to the light fitting can null the manufacturer’s guarantee.
– Use these gloves to touch the lamp during the installation to avoid smudges and dirt on its surface.
– All electronic products and batteries must be taken to separate waste collection points at the end of their working lives, they must not be disposed of in normal household waste. It is the response ability of the user to dispose of the equipment using a designated collection point or service for separate recycling of waste electrical and electronic equipment (WEEE) and batteries according to local laws.

IMPORTANT:
Switch of the mains before installing the lamp.

Remove the disk plate (A) following the movements as indicated in the arrows.
First lift the flange and rotate the disk plate till it’s loose.
Pass the electrical installation cable through the cable opening and mark the points for the fixing to the ceiling.
The drawing shows the distance between them in millimetres, if you prefer not to use the cover plate as a template.
Drill holes at the points marked in the previous step.
Place the most suitable wall plugs (not supplied) for the wall material into the drilled holes and the screws that will be used.
After passing the electrical installation cable through its opening, fix plate (A) to the ceiling using the most appropriate screws (not supplied).
Make the electrical connection to the mains supply via the connecting blocks (B) as indicated in point 6.
Holding the body of the light fitting clip on the carabiners (C) to their housing on the disk plate.
NOTE: Do not release the light fitting till the carabiners are connected.
Connect the electrical connection strips to the connection blocks (B).
IMPORTANT: Do not connect white strip with black strip.
Assemble the body of the light fitting to the disk plate. Push upwards till the spigots (D) are placed in the holes. Turn the body of the fitting slowly and when it butts up against the screw lift the flange and complete the rotation.