lorelli Enjoy Baby Rocker Instruction Manual
- June 12, 2024
- lorelli
Table of Contents
lorelli Enjoy Baby Rocker
SAFETY REQUIREMENTS
- WARNING! This product is suitable for use by babies ranging from O+ months and with a maximal weight 9 kg.
- WARNING! Do not use the reclined cradle once your child can sit unaided. This reclined cradle is not intended for prolonged periods of sleeping!
- WARNING! Never leave the child unattended!
- WARNING! Always use the restraint system!
- WARNING! Do not place the rocking chair on uneven surface! Shall be grounded in places with a slope not more than 3 degrees!
- WARNING! Toy bar is an additional article! Keep removed toy bar on a safety place! Never use the toy bar to carry the reclined cradle!
- WARNING! Never use on any elevated surface, since child’s movement may cause the product to slide or tip over. Use only on floor.
- WARNING! Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffocation in soft surfaces.
- WARNING! Never use as a carrier or lift while child is seated!
- WARNING! It is dangerous to use this reclined cradle on an elevated surface, e.g. a table.
CAUTION: This package contains small parts in its unassembled state!
- Put on horizontal and even surfaces.
- On adjusting the backrest you must be sure that the mechanism is well locked in the chosen position.
- Use the upright position only when child has developed enough upper body control to sit without leaning forward.
- Do not use the rocker as a car seat as this is not its function.
- Do not leave the rocker near a switched on fan, heat sources, sharp objects and water containers.
- This reclined cradle does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
- Do not use accessories or replacement parts other than those approved by the manufacturer.
- Adult assembly is required. Tool needed for assembly: screwdriver (not included}.
- Requires 2×1 ,5V ,,D” (LR20) alkaline battery (not included) for soother operation.
- Images on the title page and in the instruction manual are only illustrative and may differ from the real product.
- Do not use the reclined cradle if any components are broken or missing.
PARTS
- Side rails – 2 pcs.
- Pad – 1 pc.
- Toy bar – 1 pc.
- Soothing unit – 1 pc.
- M3,5 x 18 mm. Screw – 2 pcs.
- M5 x 20 mm. Screw – 4 pcs.
ASSEMBLING
WARNING: Required tool for assembling – Cross screwdriver ( not included in the set)
- Lift the long and short end of each side rail. Picture 2;3
- Fit the soothing unit into the slots in each side rail (Picture 4 bottom view) and tighten the screws ( Picture 5). Hint: The soothing unit is designed to fit only one way. If it does not seem to fit, turn it around and try again.
- Fit the rear cross Brace ( attached to the pad) onto each side rail, insert the screws and tighten . Picture 6;7
- Turn the assembly upright. Fit the free end of each hinged rail into the socket in the opposite end of each side rail. Push to “Click ” each rail in place. Picture 8 side view
- Insert the ends of the seat back tube ( inside the pad ) into the sockets in the side rails ( Picture9) Push down on the seat back tube until you hear a “Click” on each side. Pull up the seat back tube to be sure it is secure.
- Insert and “snap ” the pegs on the front and sides of the pad into the holes in the soothing unit and side rails. Picture 10;11
- Insert and “snap ” the toy bar plugs into each retainer socket ( Picture 12). The toy bar is designed to fit only one way. If it does not seam to fit, turn it around and try again. Hint: The tov bar is removable. Press the ends of the latches and lift the tov bar.
CHANGE BATTERY
Find the cover of the battery compartment on the back of the musical toy.
Picture 13
-
Loosen the screws on the battery cover with a screwdriver. Open the cover.
-
Place 2 pcs. 1,5 V type D (LR20) alkaline batteries (not included as indicated in the inside of the battery compartment.
Tip: It is recommended the use of alkaline batteries for extended operation. -
Reinstall the battery cover and tighten the screws with a screwdriver. Do not tighten excessively.
-
If the product starts with malfunction, it may be necessary to reset the electronics. Remove batteries and then insert them again.
-
When the sound begins to weaken or stop, it’s time to change the battery by an adult!
BATTERIES SAFETY INFORMATION
WARNING! In some special condition, from the battery may leak the liquid, which may cause a chemical burn or damage the product. To avoid battery’s leakage:
- Do not mix old and new batteries or different types of batteries like alkaline, standard (carbon-zinc) or rechargeable batteries (Ni-Cr)
- Please insert the batteries as indicated inside of the battery compartment.
- If you don’t use this product for a long time, please remove the batteries. When the batteries run of remove it from the product. Please carefully dispose the waste batteries. Do not dispose the batteries in to the fire. The battery may explode or leak.
- Do not cause short circuit of the batteries terminal.
- Use only the same batteries or batteries from one type as is required.
- Do not recharge non rechargeable batteries.
- Take out the batteries from the product before recharging.
- If you use rechargeable batteries, the charging should be under adult control.
SET UP AND USE
- Adjusting of the frame: WARNING: Do not adjust when the child seat into the seat ! Lift the seat back to extend the frame for toddler use . Picture 14. While pressing the buttons on the back of the side rails, push the seat back to shorten the frame for newborn or older baby use. Picture 15
- Rotate each kickstand down (Picture 16 ) to use as a stationary seat. Rotate each kickstand up (Picture 17 ) to use as a rocker.
- Adjusting of the seat back: Lift the seat back and fasten the straps on the back of the seat. Make sure you hear a “Click” Picture 18. Unfasten the straps on the back of the seat and lower the seat back . Picture 19
SECURE YOUR CHILD
WARNING: Always use the restraint system! Picture 20 Place your child
into the seat.
- Position the restraint pad between your child’s legs. Fasten the waist belts to each side of the restraint pad. Make sure you hear a “Click”on both sides. Check to be sure the restraint system is securely attached by pulling it away from your child. The restraint system should remain attached. Tighten each waist belt so that the restraint system is snug against your child.
- Adjusting the length of the belts: To tighten – Feed the anchored end of the waist belt up through the buckle to form a loop (1) Picture 21.1 Pull the free end of the waist belt (2). To loosen – repeat the steps backwards. Picture 21.2
SOOTHING VIBRATIONS AND MUSIC
- Make sure your child is properly secured in the seat Picture 22
- Press the middle button “1” to turn on. Press again to turn on the vibration. Press button “2” for music or button “3” for nature sounds. To turn off press again button “1”. Note: The soothing unit turns off after approximately 30 min. Press the button “1” to restart. If the vibrations are weak or missing, change the batteries.
- Size of the lounge. Picture 23
FOLD FOR PORTABILITY AND STORAGE
- Press both frame release buttons. Picture 24
- Lift the back rails from the side rails. Picture 25
- Push the back rails toward the front rails. Picture 26
- Lower the seat back. Picture 27
MAINTENANCE AND CARE
- Wash the pad with cold water and soft soap. Dry naturally. Do not use bleach. Tumble dry separately on low heat and remove promptly.
- The frame, toy bar and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue. Do not immerse the frame or the toys.
Didis Ltd.
Bulgaria, Shumen, 6 Trakia-iztok Street
Phone: +359 54 850 830
e-mails: home.market@didis-ltd.com;
export@didis-ltd.com
Unic importator in Romania
DIDIS INTERNATIONAL
Strada Sfantul Pantelimon Nr.1
Oras Pantelimon, Judetul Ilfov
Phone: +40 21 211 65 60
Fax: +40 21 210 65 62
E-mail: office@didis.ro
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>