KINGWORKS ITSPF Portable Solar Fan Rechargeable for Camping Instruction Manual

KINGWORKS ITSPF Portable Solar Fan Rechargeable for Camping

Product Details

chargement
USB Cable| USB Cable| USB-Kabel| Cable USB| Câble USB
Charging status display| Charging status display| Ladezustandsanzeige| Pantalla de estado de carga| Indicateur de charge

Product Usage Instructions

Charging:

• To charge the product using a USB cable, connect the USB cable to the charging port.
• The charging status display will indicate the charging progress.
• When the product is running and charging at the same time, the indicator light will always flash red.
• Do not wash the product while it is being charged to avoid electric shock injury.

Solar Charging:

• The solar panel will automatically charge when exposed to sunlight. Ensure that sunlight hits the solar panel vertically for efficient charging.
• Do not use fluorescent lamps or indoor lamps as a charging light source.
• The time required to fully charge the product using solar energy is approximately 14 hours, but it may vary depending on sunlight conditions, ambient temperature, season, etc.
• Do not place the product in high-temperature places such as a car during summer, as it may cause heat, fire, damage, and other failures.

Running and Operation:

• To start the product, press the air supply button. The weak wind will start running, and the indicator light will indicate the wind power.
• Each time the air supply button is pressed, the wind power will switch.
• To stop the product when it is running, long-press the air supply button.
• The natural wind button and timing button can be used for specific functions.
• When the remaining power is less than 10%, the indicator light will flash to indicate low battery. The product will stop running when the battery is out of power.

PRODUCT DETAILS

Front

Back

Side

USB Cable

INSTRUCTION

Angle
The angle at which this product can be opened.
Notice

• Be careful not to pinch your fingers when close.
• Do not run with the back closed.
• Do not open beyond the openable angle range.

CHARGING PORT
*This product is not fully charged when it leaves the factory, please check before use.

1. USB charging
2. Charging status display
   Side lights will light up when charging starts

Charging

When the product is running and charging at the same time, the indicator light is always flashing red.
Notice
Do not wash the product while it is being charged, as it may cause electric shock injury.

Solar charging

1. The solar panel will be automatically charged when the sun shines on it (lights such as fluorescent lamps and indoor lamps cannot be used as a charging light source)
   The time required to fully charge by solar energy is about 14 hours (charging time varies depending on sunlight conditions, ambient temperature, season, etc.)

2. Charging status display

   • The side light will light up when charging starts (see the image.
   • Do not put it in a high temperature place such as a car in summer, it will cause heat, fire, damage and other failures.

3. Each button function

   • Air supply button
   • Press the air supply button, the weak wind starts to run, the Lo light indicating the wind is on. Each time the air supply button is pressed, the wind power is switched (the wind power switch is shown in the figure below).
   • When running, long press the air supply button to stop running.
   • During operation, when the remaining power is less than 10%, the indicator light starts to flash, and stops lighting when the battery is out of power.
   • Timing button
   • The timing can be set by pressing the timing button during operation, and the display light “2” is on at this time.
   • Press the timer button again to switch the timer time.
   • After the timing is completed, the indicator light will turn off .
   • After setting the top time, if you press the air supply button or stop the operation, the timer will be canceled.
   • natural wind button
     Simulate natural wind for air supply and feel comfortable.

4. Use as a power bank
   This product can also charge other devices. When the remaining battery power is lower than 10%, the indicator light will start to flash.
   Notice
   The USB data cable used for charging needs to use the special cable of the charging product being used (PS: Please confirm the rated power of the charging device in advance, if the output power of this product exceeds the output power, it cannot be charged).

Cleaning

For service life and effect, please clean it regularly.

1. Screws as shown below
   Remove the screw by turning it counterclockwise with a screwdriver.
   Notice
   The screws are small, don’t lose them The screws are small, don’t lose them.

2. Remove front leaf
   Put your hand on both ends of the fan blade and press counterclockwise to remove.

3. remove fan blades
   Notice
   The blades may be embedded tightly and require a little force to use.

   • Please perform the reverse operation of the removal (refer to the following figure for the point of alignment).
   • The concave part A of the blade is mounted on the convex part B of the motor shaft of the main body, and is tightened with arotator (rotate counterclockwise).
   • Match the convex part on the inner side of the front leaf with the concave part of the main body, tighten the front leaf clockwise, and align the screw holes of the main body with the screw holes of the front leaf.
   • Tighten the screw clockwise with a screwdriver.

Precautions

• Please do not charge from the seat of the car.
• If there is abnormal operation, please stop using it immediately and contact our company (Support@Itehil.com).
• Don’t get caught in things like hair or rope.
• Don’t put your hand in it, especially with small children.
• When cleaning, do not wash the part with the battery.
• Do not run the product off.
• Do not damage the solar panel, otherwise the charging efficiency will be reduced or it will not be able to charge.
• Do not use volatile oil, thinner, alcohol, etc. for cleaning.
• When using it outside, be careful not to get wet by rain.

Product Specifications

Product size        (approx.) W270×D95×H315 (closed state)

Weight: Body| (Approx.) 1.7Kg.
Built-in battery| Li-ion battery DC3.7V 10,000mAh.
Full charging time| USB charging: (about) 10 hours (when using an AC charger) Full sunlight: (about) 14 hours (affected by sunshine conditions, temperature, season, etc.)
Continuous use time| (about) 10 hours (running in [Turbo] mode)
Rated input current| USB-C DC5V / 2A;USB-C DC5V USB-C DC5V / 2A| / 2A;USB-C DC5V / 2A;USB-C DC5V / 2A
Rated output current| USB-A DC5V / 1A;USB-A DC5V USB-A DC5V / 1A| / 1A;USB-A DC5V / 1A；/USB-A DC5V / 1A
Bonus| USB cable (USB-C/A length about 2m)/USB 线（USB-C/A
Material| ABS resin, polycarbonate, PET.

After-sales service

• We provide 15-day unconditional return and 1-year warranty from the date of purchase.
• If you have any questions, please consult the dealer you purchased from or our company (support@itehil.com).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>