THE HOME DEPOT TV1379 Colton 47.75 Inch Charcoal Gray TV Stand Instruction Manual

THE HOME DEPOT TV1379 Colton 47.75 Inch Charcoal Gray TV Stand

Product Information

This product is a TV stand, designed to hold and support a television. It is recommended to assemble the furniture with the help of two people. The furniture is made in China.

Product Usage Instructions

1. Before beginning assembly, carefully remove all parts and hardware from the carton, along with any protective packaging. Set aside the hardware kit before discarding the packaging. Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
2. Assemble the furniture on a soft surface to prevent scratching or damaging the parts during assembly.
3. Follow the provided diagram to connect the panels. Insert the Cam Screw into the small hole in the adjoining panel.
4. Insert the Cam Lock into the large hole, ensuring that the arrow and the opening in the Cam Lock are facing the Cam Screw.
5. Repeat steps 3 and 4 for all necessary connections.
6. Do not overtighten screws. Be cautious not to tighten them too much.
7. Once assembly is complete, ensure that all screws are properly tightened. If necessary, readjust them.
8. The finished product is ready for use.

PRE-ASSEMBLY

Two people are recommended to assemble this furniture. Carefully remove all parts and hardware from carton, along with any protective packaging. Locate and set aside the hardware kit before discarding packaging. Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware. Assemble the furniture on a soft surface, and take extra care not to scratch or damage parts during the assembly.

PRECAUTIONS — READ ALL BEFORE BEGINNING ASSEMBLY

Do not place items on the shelves which exceed the maximum weight limits of:

• Top shelf: 75 lbs. (34.0 kg)
• Lower shelves: 25 lbs. (11.3 kg) each

Usage with televisions or loads heavier than the maximum weights specified may result in instability, causing tip-over and resulting in death or serious injury. When in use, this furniture must be placed on a flat, solid and level surface. Do not climb or step on the shelves. Remove ALL items from the furniture before attempting to move the furniture. Do not use a drill or power tools to assemble this furniture, as it may weaken or damage parts. When moving the furniture, do not lift the furniture by the top shelf.

PARTS

NOTE: This illustration is for parts identification/orientation purposes only. For assembly, see following pages.

HARDWARE

INSTALLING THE CAM LOCKS

COMMENT INSTALLER

1. Screw the Cam Screw into the prethreaded hole. Tighten with a screwdriver until snug.
2. The base of the Cam Screw should be flush with the panel.
3. Connect the panels. Insert the Cam Screw into the small hole in the adjoining panel.
4. The head of the Cam Screw should be visible through the large hole.
5. Insert the Cam Lock into the large hole. Make sure the arrow and the opening in the Cam Lock are facing the Cam Screw.
6. Using a screwdriver, turn the Cam Lock at least 90° clockwise to lock the two panels firmly together.

Installation

THE EDGES SHOULD BE FLUSH, AS SHOWN.

NOTE: DO NOT OVERTIGHTEN SCREWS.

With the help of an assistant, turn TV stand upright.

View from rear of furniture.

Finished

NOTE: Use the leveling feet to make sure furniture is level on the floor before using.

CARE INSTRUCTIONS

• Wipe clean with a soft, dry cloth or static duster.
• Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the table’s finish.
• Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-tighten if necessary.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>