RONIS Tronic Pro Electronic Lock Instruction Manual
- June 12, 2024
- RONIS
Table of Contents
RONIS Tronic Pro Electronic Lock
Product Information
The Tronic Pro is a product that requires assembly and comes with a drilling template. It includes right and left hand doors and is designed to be used with an 18mm panel thickness. The product also includes accessories such as screws and a T20 Torx Security screw.
Drilling template
**ASSEMBLY
**
Accessories
Right door assembly
Left door assembly
Important notes
-
Verify that the cable is properly connected (straight and untill the bottom). Don’t push any key during the wire assembly process.
-
Relase the batteries thanks to T20 Torx Security screw located on the opposite of the battery case Verify that the batteries are in the right polarity (as indicated in the battery box).
IMPORTANT
The battery pack must remain connected during the release of the batteries. Otherwise, the internal clock will lose the time configuration.
-
Verify that the screws are not fastened too tight (<20kgf/cm2).
-
Verify that the latch works smoothly in and out, without any frinction with the door frame.
LED lights
Batteries
- Make sure the battery pack contains full powered batteries (don’t screw the battery pack too tight to avoid breaking the mechanism)
- If the lock is closed, introduce the user code (or the master one) to open it.
- Replace the old batteries for new ones and disconnect the battery pack.
Product Usage Instructions
- Start by assembling the right hand door. Use the drilling template provided to drill holes with a diameter of 2.5mm.
- Repeat step 1 for the left hand door.
- Attach the right door assembly using section A-A as a guide.
- Attach the left door assembly using section A-A as a guide.
- Connect the blue part of the right door to the side of the ledge. Ensure it is securely connected.
- Connect the blue part of the left door to the side of the ledge. Ensure it is securely connected.
- Verify that the cable is properly connected and straight at the bottom.
- Release the batteries by unscrewing the T20 Torx Security screw located on the opposite side of the battery case.
- Check that the batteries are correctly inserted according to the indicated polarity in the battery box.
- Ensure that the battery pack remains connected during the battery release process to avoid losing time configuration on the internal clock.
- Make sure not to fasten the screws too tight during assembly.
Note: Do not push any key during the wire assembly process.
Important
We suggest to change once every three years the batteries for ensure their good condition. After a long time, the batteries can deteriorate and damage the lock, especially in hot environments Do not clean the locks with cleaning products with hydrochloric acid, lye or corrosive components, especially on the metallic parts.