RONIS DOM Tronic Slim Keypads Instruction Manual
- October 30, 2023
- RONIS
Table of Contents
RONIS DOM Tronic Slim Keypads
Product Information
The Tronic Slim is a product that comes with right and left hand doors and accessories that are required for assembly. The product also comes with a drilling template to assist with installation. The doors are assembled separately, and there are specific warnings that must be followed during the assembly process.
Usage Instructions
Before starting the assembly process, ensure that the cable is properly connected and that no keys are pushed during the wire assembly process. The batteries must be released using the T20 Torx Security screw located on the opposite side of the battery case. Ensure that the batteries are in the correct polarity as indicated in the battery box. It is important to note that the battery pack must remain connected during the release of the batteries; otherwise, the internal clock will lose the time configuration.
To assemble the right-hand door, use the drilling template to drill a hole using a 2.5 drill bit. Then, follow the steps in section A-A to assemble the right-hand door. Ensure that you connect the blue part to the side of the ledge as indicated in step 4. Repeat these steps for the left-hand door assembly.
During assembly, verify that the screws are not fastened too tight, as indicated in assembly step 3. Failure to follow this warning could result in damage to the product.
Drilling template
Right hand door
Left hand door
Accessories
Right door assembly
Left door assembly
Verify that the cable is properly connected (straight and untill the bottom).
Don’t push any key during the wire assembly process.
Relase the batteries thanks to T20 Torx Security screw located on the opposite
of the battery case
Verify that the batteries are in the right polarity (as indicated in the
battery box).
IMPORTANT
The battery pack must remain connected during the release of the batteries.
Otherwise, the internal clock will lose the time configuration.
Important notes
Batteries
If the yellow LED blinks
Dead batteries: replace batteries.
- Make sure the battery pack contains full powered batteries (don’t screw the battery pack too tight to avoid breaking the mechanism). make sure to use the USB-C adaptor.
- If the lock is closed, introduce the user code (or the master one) to open it.
- Replace the old batteries for new ones and disconnect the battery pack.
Important
We suggest to change once every three years the batteries for ensure their
good condition. After a long time, the batteries can deteriorate and damage
the lock, especially in hot environments Do not clean the locks with cleaning
products with hydrochloric acid, lye or corrosive components, especially on
the metallic parts.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>