TOSHIBA TE3-KP-Kit Voltage Solid State Starter Instructions
- June 12, 2024
- Toshiba
Table of Contents
TOSHIBA TE3-KP-Kit Voltage Solid State Starter
Product Information
The product is a keypad assembly that is designed to be mounted on a door or panel with a specific cutout size of 3.6 x 4.4 inches (91mm x 112mm). It comes with a pressure-sensitive adhesive gasket for easy installation.
Product Usage Instructions
- Begin by removing the keypad assembly from its existing mount location.
- Disconnect the existing short cable from the keypad assembly and discard it.
- Peel off the backing on one side only of the provided pressure-sensitive adhesive gasket.
- Attach the gasket to the back of the keypad.
- Peel off the backing from the gasket attached to the keypad.
- Place the keypad on the outside of the door or panel with the 3.6 x 4.4-inch (91mm x 112mm) cutout.
- Attach the longer cable provided in place of the removed short one.
DIMENSIONS
INSTALLATION INSTRUCTIONS
- REMOVE THE KEYPAD ASSEMBLY FROM THE EXISTING MOUNT LOCATION.
- DISCONNECT THE EXISTING SHORT CABLE FROM KEYPAD ASSEMBLY AND DISCARD IT.
- PEEL OFF THE BACKING ON ONE SIDE ONLY OF THE PROVIDED PRESSURE-SENSITIVE ADHESIVE GASKET.
- ATTACH THE GASKET TO THE BACK OF THE KEYPAD.
- PEEL OFF THE BACKING FROM THE GASKET ATTACHED TO THE KEYPAD.
- PLACE THE KEYPAD ON THE OUTSIDE OF THE DOOR OR PANEL WITH 3.6″ X 4.4″ CUTOUT.
- ATTACH THE LONGER CABLE PROVIDED IN PLACE OF THE REMOVED SHORT ONE.
MADE IN HOUSTON, TEXAS U.S.A.
THIS MATERIAL IS THE EXCLUSIVE PROPERTY OF TOSHIBA INTERNATIONAL CORPORATION
AND SHALL NOT BE REPRODUCED, USED, OR DISCLOSED TO OTHERS UNLESS PRIOR WRITTEN
AUTHORIZATION IS OBTAINED.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>