RHINO-RACK 43179 Cam Buckle Pioneer Pickup Kit User Manual

June 12, 2024
RHINO RACK

RHINO RACK logo Cam Buckle Pioneer Pickup Kit 43179
User ManualRHINO RACK 43179 Cam Buckle Pioneer Pickup
Kit

43179 Cam Buckle Pioneer Pickup Kit

Important:
Please read these instructions carefully prior to installation.
Please refer to your fi tting instruction to ensure that the alloy tray is installed correctly.
Check the contents of this kit before commencing fi tment and report any discrepancies.

Important Information

Maximum Lashing Capacity: 225kg/ 496Lbs per set.
Recommendations:
Use only non stretch fastening ropes or straps. Do not overload your Rhino- Rack Pioneer Platform/ Tray or Tradie Tray and roof bars. Check your vehicle’s roof carrying capacity. Exercise caution when driving off road as vehicle roof height has been increased. Be aware of increased sensitivity to cross winds.

  • Regularly check strap condition for any signs of abrasion. Immediately replace. Do not use a strap that is damaged.
  • Do not overload roof capacity. Always evenly distribute load.
  • Remove load/ roof racks when putting vehicle through an automatic car wash.

Caution:
The handling characteristics of the vehicle change when you transport a load on the roof. For safety reasons, we recommend exercising extreme care when transporting large wind-resisting loads; special consideration must be taken into account when negotiating corners and under braking.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.

Rhino-Rack
3 Pike Street, Rydalmere, NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822| Document No: R809
Prepared By: Kayle Everett
Authorised By: Chris Murty| Fit time: 15min
Issue No: 03
Issue Date: 16/05/16
---|---|---

These instructions remain the property of RhinoRack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.

Pioneer Pickup Kit 43179

RHINO RACK 43179 Cam Buckle Pioneer Pickup Kit - Part

Item Component Qty Part No.
1 Security Allen Key 4mm 1 H001
2 M6x10mm Counter Sunk Screw 8
3 M6 20×20 Square Nut 8 N025
4 Pioneer Pickup Moulding 4 SP202
5 Cam Buckle for Pioneer 2 CA1461
6 Fitting Instructions 1 R809

RHINO RACK 43179 Cam Buckle Pioneer Pickup Kit - Size

  1. Assemble the Pickup kit as shown. Do not tighten hardware at this stage.RHINO RACK 43179 Cam Buckle Pioneer Pickup Kit - Pickup kit as shown
  2. Slide the Pickup Moulding into the Pioneer access slot as shown. If this proves diffi cult, slightly loosen the hardware.RHINO RACK 43179 Cam Buckle Pioneer Pickup Kit - hardware Repeat steps 1-2 for opposing side.
  3. Secure your load between two or more Pickup Mouldings on the Pioneer Platform. Wrap the looped ends of the Cam Buckle sections over each Moulding as shown.RHINO RACK 43179 Cam Buckle Pioneer Pickup Kit - Pioneer Platform
  4. Pull the strap through the Cam Buckle as shown.
    Tighten over the load to be carried. Ensure load is secure before driving. Tie off any loose ends of the strap.

RHINO RACK 43179 Cam Buckle Pioneer Pickup Kit - Cam
Buckle

RHINO RACK logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals