RHINO-RACK 52100 Pioneer Alloy Tray Instruction Manual
- June 12, 2024
- RHINO RACK
Table of Contents
RHINO-RACK 52100 Pioneer Alloy Tray Instruction Manual
Important:
- Check the Rhino-Rack website to ensure you have the latest issue of these instructions.
- Please refer to your fitting instruction to ensure that the roof racks are installed in the correct locations.
- Check the contents of kit before commencing fitment and report any discrepancies.
- Place these instructions in the vehicle’s glove box after installation is complete.
- These instructions must be followed for warranty to be upheld.
Fit Time: 1 hour
Pioneer Fully Assembled Instructions
Carrying Capacity
Max system load capacity (incl. system weight), refer to Pioneer fit
sheet.
Check your vehicle owners hand book for vehicle maximum carrying capacity.
Please ensure you use the vehicle manufacturers maximum roof allowance if it
is lower than the figure listed in this instruction. Load must be evenly
distributed over the system.
Off Road: Any driven path taken that does not contain a surface
protection layer (tar/bitumen).
Vehicle Load Limit: Total permissible weight attached to the roof of the
car. This is inclusive of the weight of the roof rack system.
System Load Limit: Total permissible weight allowed on top, and attached
to roof racks whilst the vehicle is in motion.
Torque Settings
Unless stated otherwise in these instructions, all fasteners should be set to
the following torque settings – M6: 4-5Nm (3-4lbs/ft), M8: 8-10Nm
(6-7.5lbs/ft) and M10: 16-18Nm (12-13lbs/ft).
Warning
- Check part number or kit is correct for use with your vehicle.
- Do not attempt to fit the rack system to your vehicle unless you fully understand these fitting instructions. Please direct any questions regarding fitting to the dealer from where the roof racks were purchased.
- Although the system is tested and approved to AS1235-2000 / ISO 11154, off-road conditions can be much more rigorous. Extreme care must be taken in off road conditions.
- Roof racks must be removed when vehicle is put through an automatic car wash.
- With utility vehicles, the cabin and the canopy move independently. Roofracks and vehicle can be damaged if the item transported is rigidly fixed at points on both the cabin and canopy. Instead, rigidly fix to either the cabin roof racks or the canopy roof racks.
- Always ensure you fasten your load securely.
- Use only non-stretch fastening ropes or straps to attach cargo to your load.
In service maintenance checks
- All bolted connections should be checked after driving a short distance when you first install your roof racks.
- All bolted connections should be checked again at regular intervals (weekly is recommended, depending on road conditions, usage, loads and distances travelled).
- All bolted connections should be checked each time they are re-fitted
Note for Dealers and Fitters
It is your responsibility to ensure these fitting instructions are given to the end user or client. These instructions remain the property of Rhino-Rack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
Parts List
Platform #| L x W(mm)| L x W(inches)| G| H| I|
J| K| L| M
---|---|---|---|---|---|---|---|---|---
52100| 1528 x1236| 60′ x 49′| 4| 3| 52| 52| 12| 16| 6
52101| 1528 x 1376| 60′ x 54′| 5| 3| 62| 62| 12| 16| 6
52102| 1928 x1236| 76′ x 49′| 4| 5| 76| 76| 12| 16| 6
52103| 1928 x 1376| 76′ x 54′| 5| 5| 90| 90| 12| 16| 6
52104| 2128 x 1426| 84′ x 56′| 5| 5| 90| 90| 12| 16| N/A
52105| 2728 x 1465| 107′ x 58′| 5| 6| 104| 104| 12| 16| N/A
52107| 2128 x1236| 84′ x 49′| 4| 5| 76| 76| 12| 16| N/A
52108| 1828 x 1426| 72′ x 56′| 5| 5| 90| 90| 12| 16| N/A
52109| 1328 x1236| 52′ x 49′| 4| 3| 52| 52| 12| 16| N/A
52110| 1328 x 1376| 52′ x 54′| 5| 3| 62| 62| 12| 16| N/A
52111| 1328 x 1426| 52′ x 56′| 5| 3| 62| 62| 12| 16| N/A
52112| 928 x 1426| 37′ x 56′| 5| 2| 48| 48| 12| 16| N/A
52113| 1528 x 1426| 60′ x 56′| 5| 3| 90| 90| 12| 16| N/A
52114| 1228 x 952| 48′ x 37′| 3| 1| 22| 22| 12| 16| N/A
52115| 1478 x 1184| 58′ x 47′| 4| 1| 28| 28| 12| 16| N/A
52119| 2528 x 1586| 100′ x 62′| 5| 6| 104| 104| 12| 16| N/A
52120| 1528 x 1586| 60′ x 62′| 5| 3| 62| 62| 12| 16| N/A
52121| 1228 x 1426| 48′ x 56′| 5| 3| 62| 62| 12| 16| N/A
Pioneer Fully Assembled Instructions
Rhino-Rack
22 Hanson Pl, Eastern Creek 2766, Australia, NSW (02) 8846 1900
rhinorack.com
Document No: R1812
Issue No: 04
Issue Date: 29/04/2021
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>