bathlife STIMMA TAPP Roof Shower Set Instruction Manual
- June 12, 2024
- bathlife
Table of Contents
bathlife STIMMA TAPP Roof Shower Set
Product Information
The product is called STIMMA TAPP. It is a manual product with the model number EN 1111. The user manual provides important information, assembly instructions, tools required for installation, maintenance instructions, tightening guidelines, and components of the product. It also includes a spirit-level, drill, mixer, water channel cartridge, thermostatic cartridge, lower shower profile, ceiling shower, shower hose, and concrete screws as part of the product.
Product Usage Instructions
- Assembly: Follow the assembly instructions provided in the user manual. Make sure to hire a licensed and/or authorised professional for installation.
- Tools: The product requires a spirit-level for accurate installation and a drill for drilling holes in concrete or other massive materials.
- Maintenance: For maintenance, remove the cartridge from the product and soak it in detergent or white vinegar for 1 hour. Rinse thoroughly with water before reinserting it according to the removal and reinsertion guide.
- Tightening: Follow the tightening guidelines provided in the user manual for optimal performance.
- Components: The product includes various components such as a mixer, water channel cartridge, thermostatic cartridge, lower shower profile, ceiling shower, and shower hose. Refer to the user manual for detailed information on each component.
Important information
- Before installation, check the following component list carefully.
- Before installation, flush pipes carefully.
- For installation, hire a licensed and/or authorised professional.
- For installation, connect the hot and cold water supply properly.
- After installation, turn on the water to check leakage in each joint.
- Recommended operating temperature 4 −90 °C
- Recommended operating pressure 1 − 6 bar
Tools
Components
Tightening
- Drill
- Seal
- Plug
- Screw
- Concrete or other massive material
- Wood beams, nogging pieces, or other base tested and approved for mounting, such as some boards
Assembly
Drawing
All dimension has error ± 5 mm, the actual installation size should be basic on the actual product.
- If you have questions, please contact us.
- If any part is broken, do not use the product before repairing it.
- When cleaning, do not use bleaching or abrasive chemicals.
- When cleaning in general, use a soft cloth and gloves.
- Turn off all valves to stop any water flow during any maintenance.
Removing or inserting cartridge
Perform the steps in the reverse order after inserting a new cartridge
.
Maintenance
Cleaning of cartridges
Once removed, soak the cartridge in detergent or white vinegar for 1 hour.
After, rinse thoroughly with water. Reinsert according to the removal and
reinsertion guide.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>