FXLuminaire DIM-LV Spot Light Installation Guide

INSTALL NOTE: DIM-LV
Installation Guide

NOTE: Dimming levels are unique to each lighting fixture and lamp. Some lamps and fixtures may shutoff prior to reaching 0% intensity.

INTRODUCTION

Odis asimin reprent orrorep ellaut quost ratia digeni unt, cus sunt duntia illaccus autatur, sit lit inctae ligentem is peris sus undae veliciet ditionsed estotat iaecto volorecto deligendis voluptas reium et, int, sequatus.
Ma ipsa apid esecest labo. Nam reseque dem que qui beaque ipitem rae non ra simagnimus molestrumet aditat ut odit,
Backlit Display – Displays current dimmer intensity value
Preset Buttons – Save custom intensity settings
Dimming Control – Increase or decrease system intensity

JUNCTION BOX INSTALLATION

1. Connect field wires from transformer to dimmer wires (black). Connect fixture wires to dimmer wires (red).

2. Install dimmer inside the junction box

3. Install the faceplate (not included)

BASIC OPERATION

All fixtures wired to the dimmer will illuminate to the intensity set on the DIM-LV. When lighting transformer is powered on (output low voltage to field), the dimmer will turn on the fixtures to the last set intensity value.

1. Install DIM-LV per the steps above.
2. Turn on the lighting transformer and confirm that the DIM-LV display is illuminated. The LCD will display the last set intensity value. For new installs, the value will be 50%.
3. To adjust fixture intensity, use (+) or (-) buttons to increase or decrease intensity. Press and holding down (+) or (-) button increases the speed of adjustment.

Note: Dimming levels are unique to each lighting fixture and lamp. Some lamps and fixtures may shutoff prior to reaching 0% intensity.

PRESET INTENSITY

The DIM-LV has four customizable intensity buttons (1, 2, 3, and 4). Preset intensities are shown in the table below. To customize the preset buttons, follow the steps.

To change preset intensity levels, follow the instructions below.

1. Set dimmer intensity to the desired level. See Basic Operations.
2. Press and hold down desired preset button (1-4) for 5 secs or until LCD quickly flashes OFF and then back ON. The display flash indicates the intensity level has been saved to the preset button

TIP: Dedicate a preset button to 0% intensity. This button can be used as the dimmer OFF button

TROUBLESHOOTING

to each lighting fixture and lamp. Some lamps and fixtures may shut off prior to reaching 0% intensity. Determine the minimum dimming level for your fixtures by manually adjusting the intensity using (+) (-) buttons located at the bottom of the fixture.
LCD is not illuminated| • Confirm wiring per installation guide. Input field wires (wires installed into the transformer) must be wired to dimmer 12V IN (black) wires.
• Confirm transformer is powered on (output voltage).
Fixtures not turning on| • Confirm wiring per installation guide. Dimmer 12V out (red) wires must be connected to field wires (wires installed into the fixtures).
• Confirm fixtures are receiving the minimum 11 VAC operating voltage.

fxl.help/DIMLV

We have developed this series of field installation guidelines to assist you in correctly installing fixtures and transformers, ensuring customer satisfaction and trouble-free service. If you have any questions, please call your local distributor before proceeding. Follow all NEC guidelines and local electrical codes.

Learn more. Visit fxl.com
FX-349

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>