Goldair GPOC3310 2400W 10 Fin Oil Column Heater Instruction Manual
- June 4, 2024
- GOLDAIR
Table of Contents
PLATINUM
operating Instructions
10 Fin Oil Column Heater
Model: GPOC3310
This page has intentionally been left blank.
General Care and Safety Guide
YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE
INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they are supervised or have been given instruction concerning the use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
WARNING: You must not cover this appliance. Covering this appliance
presents a fire risk and will activate the safety fuse; permanently disabling
the unit.
WARNING: Do not use this appliance in small rooms when they are occupied
by persons not capable of leaving the room on their own unless constant
supervision is provided.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any
flammable material at a minimum distance of 1 meter from the air outlet.
-
Use only the voltage specified on the rating label of the appliance.
-
Keep all objects at least 1 meter from the front, sides, and rear of the appliance.
-
This appliance is intended for household use only and not for commercial or industrial use.
-
Indoor use only.
-
Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock or injury.
-
Do not use the appliance if it has been dropped or damaged.
-
The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills -
Never use the appliance to dry clothes.
-
Always unplug appliances when not in use.
-
When the appliance has been unpacked, check it for transport damage and ensure all parts have been delivered. If parts are missing or the appliance has been damaged, contact the Customer Services Team.
-
Do not use if there are visible signs of damage to the appliance.
-
Do not connect the appliance to the mains supply until completely assembled and adjusted.
-
Ensure hands are dry before handling the plug or main unit.
-
Ensure the appliance is on a flat, stable, heat-resistant surface.
-
Do not operate with the cord set coiled up as a heat build-up is likely, which could be sufficient to become a hazard.
-
Carry out regular checks of the supply cord to ensure no damage is evident
-
Do not operate this appliance with a damaged cord, or plug or after the appliance malfunctions or has been dropped or damaged in any manner. Take to a qualified electrical person for examination, electrical service, or repair.
-
Do not twist, kink, or wrap the cord around the appliance, as this may cause the insulation to weaken and split. Always ensure that all cord has been removed from any cord storage area and is unrolled before use.
-
It is recommended that this appliance is plugged directly into the wall socket. Power boards are not rated to supply power to high-wattage appliances.
-
A correctly specified, undamaged extension cord may be used with this appliance provided it is used in a safe manner.
-
Do not remove the plug from the power socket until the appliance has been switched off.
-
Do not remove the plug from the power socket by pulling cord; always grip plug.
-
Do not place the cord under the carpet or cover it with rugs or furniture. Arrange the cord so it cannot be tripped over.
-
Don’t place appliances on bedding or on thick & long carpets where the openings may get blocked.
-
Switch off and use the handle provided when moving
-
Do not place the appliance close to a radiant heat source.
-
Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock, fire or damage to the appliance.
-
Do not sit on the appliance.
-
Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) and rinsed in hot soapy water only. Always remove the plug from the mains supply before cleaning.
-
Do not operate in areas where petrol, paint or other flammable liquids are used or stored.
-
Do not use this appliance in the immediate surroundings of a bath, a shower, a swimming pool, or other liquids.
-
The appliance must not be immersed in any liquids.
-
There are no user-serviceable parts installed in the unit.
-
Do not place the unit in wardrobes or other enclosed spaces as this may cause fire hazards.
-
This unit is not supposed to be used in or around locations where foodstuffs, works of art or delicate articles of science, etc. are stored.
-
If your appliance does not work or is not working properly, contact the place of purchase or the Customer Services Team.
Assembly
WARNING: Heater must not be used without the castor plates and castors
fitted.
Before first use you need to set the castor wheels to the widest position. To
do this slide each wheel out from the main body until they cannot go any
further and then tighten the screws to lock them in position. Repeat this for
the rear castors.
The castors shown below in the correct operation
position
Operating Your Oil Column Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the unit
before use. Please follow the below instructions.
WARNING: In order to avoid overheating or fire, do not cover the heater.
WARNING: Keep all objects at least 1 meter from the front, sides, and
rear of the appliance.
WARNING: Do not use this heater with a programmer, separate timer,
remote-control system, or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned
incorrectly.
WARNING: Never leave this heater unattended when in use. Ensure the
heater is on a flat, stable, heat-resistant surface. Once the heater is in a
safe operating position and all switches are in the off position, insert the
power plug into the mains outlet and switch it on.
CAUTION: Ensure the power cord is not tight because if pulled it may
partially pull the plug from the socket. A partially inserted plug will
overheat the plug and socket and could result in fire.
HEAT CONTROL SWITCH
Check that the heat control switch is set to Off position before plugging the
heater into the mains supply.
The control switch positions are:
O OFF
LOW Low heat setting
MED Medium heat setting
HIGH High heat setting
For greater economy, use the High Heat setting initially and then switch to
the Lower
Heat settings.
THERMOSTATIC CONTROL
- Rotate the thermostat knob clockwise until you reach the maximum position.
- When the room reaches a temperature that is comfortable for you, slowly turn the knob anti-clockwise until the heater just turns off (you will hear a click).
- The heater will now cycle on and off to maintain the comfort level you have set.
- Take note of this setting position for future use
TIMER
You must set the time prior to programming the Timer. To do this; turn the
outer dial of the timer in a clockwise direction until the time of the day
(24-hour clock)corresponds with the triangular marking. For example, if it is
2 pm (1400 hours) then set the triangular mark in line with 14. One complete
turn of the dial corresponds to 24 hours. There are 96 “riders”, positioned
around the dial, each rider represents 15 minutes. Where all the “riders” are
pushed to the outside of the timer the heater will be ON continuously. To set
a specific time for example: If you want the heater to be on from 6 pm to 10
pm, then set all the riders from 18 to 22 (1800 hours to 2200 hours) to the
outside of the rim, and all the riders to the inside of the timer. The unit
will then turn on automatically at 6 pm and off again at 10 pm.
SAFETY DEVICES
This appliance has three protection devices:
- Tilt Switch – this will automatically turn the appliance off if the appliance is not in the correct operating position.
- Resettable Thermal Link – this will automatically disconnect the power to the appliance at a pre-set overheat temperature. After cooling down it will reset and power on again. If this occurs, investigate what is causing the appliance to overheat.
- Thermal Fuse – this disconnects the appliance permanently in case of overheating. (It is nonresettable).
CAUTION: The appliance generates heat during use. Precautions must be taken to prevent the risk of burns, scalds, fires or other damage to persons.
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble-free operation:
-
Unplug the heater from the main supply before cleaning.
-
Ensure that the heater has been allowed to cool down completely before cleaning.
-
The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills. -
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
-
Never use solutions such as petrol, thinners, or polishing agents.
-
Ensure the heater is dry before plugging back into the mains supply.
This appliance cannot be serviced. Do not attempt to dismantle.
There are no user-serviceable parts. For service or repair, contact an
authorised electrical service technician.
When disposing of the appliance, follow the regulations concerning the
disposal of oil.
PROOF OF PURCHASE
To receive a warranty retain the receipt as proof of purchase.
SUPPORT AND TECHNICAL ADVICE
Goldair – New Zealand
Monday – Friday 8 am-5 pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@cdb.co.nz
Goldair – Australia
Monday – Friday 8 am-5 pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
info@cdbgoldair.com.au
Three Year Warranty
Thank you for purchasing this Goldair Platinum product. Your product is
warranted against faults and manufacture when used in normal domestic use for
a period of three ears. In non-domestic use, Goldair limits the voluntary
warranty to three months. Goldair undertakes to repair or replace this product
at no charge if found to be defective due to a manufacturing fault during the
warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident,
incorrect installation, or work carried out by anyone other than a qualified
electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and
remedies available to you under the law in relation to the goods or services
to which this warranty relates. In Australia, our goods come with guarantees
that cannot be excluded under the Australian Consumer Law. You are entitled to
a replacement or refund for a major failure and compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
In New Zealand, this warranty is additional to the conditions and guarantees
of the Consumers Guarantee Act (1993).
Goldair – New Zealand
CDB Goldair
PO Box 100-707
N.S.M.C
Auckland
Phone +64 (0)9 917 4000
Phone 0800 232 633
www.goldair.co.nz
Goldair – Australia
CDB Goldair Australia Pty
PO Box 574
South Morang
Victoria, 3752
Phone +61 (0)3 9365 5100
Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au
Goldair Three-Year Warranty (IMPORTANT: Please complete and retain this
warranty card)
Name——————————————-
Addres———————————————
Place Of Purchase—————————————-Date Of Purchase——————————–
Name Of Product————————————————–Model Number————————
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User
Manual may differ slightly from the actual product.
New Zealand
PO Box 100707,
North Shore Mail Centre,
Auckland, 0745
www.goldair.co.nz
Australia
PO Box 574,
South Morang,
Victoria, 3752
www.goldair.com.au
Documents / Resources
|
Goldair GPOC3310 2400W 10 Fin Oil Column
Heater
[pdf] Instruction Manual
GPOC3310 2400W 10 Fin Oil Column Heater, 2400W 10 Fin Oil Column Heater, 10
Fin Oil Column Heater, Fin Oil Column Heater, Oil Column Heater, Column
Heater, Heater
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>