24 7 GOLF Golf Simulator Enclosure Instruction Manual
- June 12, 2024
- 24 7 GOLF
Table of Contents
24 7 GOLF Golf Simulator Enclosure
Golf Simulator Enclosure
The Golf Simulator Enclosure is designed to create a realistic indoor golfing experience. It comes in two separate cartons, one containing the metal frame and the other containing the enclosure material with the projector screen.
Your Golf Simulator Enclosure will come in 2 Separate Cartons
1 x Long Carton – Metal Frame & 1 x Rectangular Carton – Enclosure Material with Screen
Long Carton – Metal Frame Contents
- 10 × 1A Poles – (Male-to-Female)
- 11 x 2B Poles – (Male-to-Male)
- 8 x 3A Poles – (Short Male-to-Female)
- 2 x #4 – 3-Way Front-Upper Connectors with plastic cap
- 2 × #5 – Angled 3-Way Upper-Rear Connectors
- 2 × #6 – 2-Way Front Lower Connectors with circular feet
- 2 × #7 – 3-Way Rear-Lower Connectors with circular feet
1 x Rectangular Carton – Enclosure Material with Screen
The enclosure material is a single piece construction containing the projector
screen, side panels and a ceiling panel. 
Frame Assembly
Frame Assembly Part Identification
- Step 1: Assemble the Upper Frame
- Step 2: Attach the enclosure material to the metal frame
Place the enclosure material in the center of your designated area and spread
it out. The smooth side of the hitting screen should face towards you. Secure
all four top edges of the enclosure material to the upper frame using Velcro
attachments. Start at the rear and then move to each side, finishing with the
front. Attach the enclosure to each of the vertical upright legs. Connect the
1A Poles (Male-to-Female) to each of the four vertical uprights to achieve a
height of approximately 8’6″ (2.6m). Wrap and secure the remaining perimeter
edges along all sides and the bottom lower frame.
Secure all 4 top edges of the enclosure material to the upper frame using the
Velcro attachments. Start at the rear, before moving on to each side, then do
the front last 
Once the top is secured, move around the enclosure and attach the enclosure to
each of the vertical upright legs
Connect the 1A Poles – (Male-to-Female) to each of the four vertical uprights.
Once installed your enclosure will be around 8’6” (2.6m) tall. 
Wrap and secure the remaining perimeter edges along all sides and the bottom
lower frame 
Tensioning the Screen
Tightly loop and secure the vertical tensioning straps around the lower
horizontal frame using the Velcro strapping that comes from the top of the
enclosure.
Tightly secure the horizontal straps using the Velcro strapping that comes
from the side of the enclosure.
IMPORTANT: Attach the supplied protection padding to the Velcro located
around the inside edge of the projector screen. Ensure that the pads fully
cover the corner seams. Failure to attach the padding may void the warranty
and could cause injury.
A time lapse video of this installation can be found at https://youtu.be/ArNc_2Tc2ak
For further assistance, please email play@247-golf.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>