YiHUA 948DQI Solder Fume Extractor Instruction Manual

YiHUA 948DQI Solder Fume Extractor

Thank you for purchasing this product. Please read the manual carefilllybefore-ratingand keep this manual for future reference.
Made in China
Statement : The company reserves the right to improve & upgrade products, product specifications and design are subjea to change without notice.
This product should not be thrown in the garbage. In accordance with the European directive 2012/19/EU, electronic equipment at the end of their life must be collected & returned to an authorized recycling facility.

Applications

Effectively extract and filter the fume generated from soldering via the activated carbon filter. This helps cleanse the air in your work area efficiently.

**Reference Diagram

**

1. Activated Carbon Filter {Front)
2. Fender
3. Activated Carbon Filter (Rear)
4. Power Switch

FEATURES

• Air volume approximately 2. 7m3/min
• Main unit dimensions L90Wl45Hl64mm ±5mm
• Operating Ambient Temperature 0~40°C/32~l04° F

OPERATIONS

NOTE : The helping hands are sold separately. If needed, contact our official store to purchase. If your product comes with a pair of helping hands, ple­ase install them as per the instructions below:

1. Hold one helping hand and tighten it clockwise into the screw hole (1-1-1 ). 1.2 Hold the fastener and tighten it clockwise to secure the helping hand.

2. Push the fenders from the top down into the installation slots (2-1).

3. Connect the soldering iron to the station and place the soldering iron into the soldering iron holder.

4. Installing & Removing the activated carbon filter.
   NOTE:
   A. Remove the activated carbon filter’s packaging before installing.
   B. Dust and particles may scatter when replacing the activated carbon filter. Please prepare sufficient desk protection.

5. Use a pair of tweezers to grab the top-middle position of the activated carbon filter and pull the filter out gently (4-1-1).

6. Tilt the main unit, use a pair of tweezers to grab the top-middle position of the activated carbon filter and place the bottom-end of the filter into the slots first. Then, push the rest of the activated carbon filter into the slot.
   NOTE : To prevent loss of suction, please clean the residues off the activated carbon filter regularly.

Maintenance & Precautions

1. Dust and particles may scatter when replacing the activated carbon filter, please prepare sufficient desk protection.
2. To avoid impacting the fume extraction performance negatively, DO NOT use the fume extractor in environments with strong disruptive airflows.

Troubleshooting

The noise inside the fan becomes significantly louder – This is the indication that the fan is malfunctioning. The fan needs to be replaced.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>