THORN CN B 8L35 830 Candle Bollard Instruction Manual
- June 12, 2024
- THORN
Table of Contents
THORN CN B 8L35 830 Candle Bollard
Product Information
| Product Name | Candle Bollard |
|---|---|
| Installation Instructions | LV Instalacijas instrukcija NO Monteringsanvisning |
PL
Instrukcja montazu SE Installationsanvisning RU
Drainage| Recommended to have drainage
Lighting Time| Minimum: 10 seconds, Maximum: 20 minutes
Daylight Detection| Not possible
Number of Bollards| Maximum: 3
Including Number of Masters| 1 to 3
Pilot Wire Relay| NO (for installations without pilot wire) / YES (for
installations with pilot wire)
Power Supply Voltage| 240Vac
Product Usage Instructions
Important Safety Instructions:
- Replace any cracked protective shield.
- Class II luminaires must be installed so that exposed metal work of the luminaire is not in contact with any part of the electrical installation connected to a protective conductor.
- WARNING : Class I luminaires must be earthed.
- This luminaire operates at mains voltage which must be switched off before intervention in control gear.
- Any modification to this luminaire is forbidden.
Installation Steps:
- Ensure there is proper drainage for the luminaire.
- Position the luminaire according to the desired lighting area. Avoid prolonged staring into the luminaire at a distance less than 5 meters.
- If required, connect the luminaire to a pilot wire relay for advanced control (only applicable if pilot wire relay installation is available).
- If applicable, connect the power supply to the luminaire using L (Line) and N (Neutral) terminals. For installations without pilot wire, skip this step.
- For installations with multiple bollards, ensure the maximum number of bollards does not exceed 3.
- Tighten all connections with a torque of 2.5 Nm.
- For dimming or power-switching functionality, refer to the specific instructions provided in the respective language (Francais, Sverige, Italiano).
Note : Please refer to the complete user manual for detailed information on maintenance, troubleshooting, and other important guidelines.
CANDLE BOLLARD
The luminaire should be positioned so that prolonged staring into the luminaire at a distance <2m is not expected
INSTALLATION INSTRUCTIONS
- Replace any cracked protective shield.
- Class II luminaires must be installed so that exposed metal work of the luminaire is not in contact with any part of the electrical installation connected to a protective conductor.
WARNING : Class I luminaires must be earthed.
- This luminaire operates at mains voltage which must be switched off before intervention in control gear.
- Any modification to this luminaire is forbidden
Thorn Lighting is constantly developing and improving its products. The right is reserved to change specifications without prior notification or public announcement.© Thorn Lighting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>