Glide Gear G2H 100 Axis Handheld Natural Motion Camera Rig Kit User Manual
- June 12, 2024
- Glide Gear
Table of Contents
Glide Gear G2H 100 Axis Handheld Natural Motion Camera Rig Kit User Manual
What’s included?
Assembly
-
Attach the Vertical Rails (C) to the ends of the Camera Rails (B) as shown in Fig. 1. Make sure to insert the Vertical Rails (C) so that the measurements are in the correct orientation.
-
Slide the Vertical Rails (C) onto the clamps located at the end of each arm of the Main Frame (A). Make sure that the Main Frame (A) wooden handles are facing away from the frame’s arms as pictured in Fig. 2.
-
Screw the Rail Caps (D) at the end of each Vertical Rails (C) as shown in Fig. 3.
-
You can now mount your camera onto the Camera Plate (E).
Adjustments
Using the G2H 100 with a vest and arm system
PLEASE NOTE that the G2H 100 needs to be used in combination with a Vest and
Arm system and is compatible with any vest and arm system with a pin diameter
smaller than 7/8” or 22.5mm To use the G2H 100 with your vest and arm system,
simply slide the arm’s pin inside the G2H 100 handle (F) as shown in Fig. 4
Glide Gear recommends using The G2H 100 with the G2G 1000 Vest.
The G2G 1000 Vest can be used with the arm mounted to the front of the vest as
it is usually the case but can also be used with the arm mounted to the back
of the vest as it is the case in Fig. 5 which also features the G2H 100.
website: www.glidegear.net
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>