MOUNTUP MU0028-B Full Motion TV Wall Mount for 42-75 Inches TVs Instruction Manual

MOUNTUP MU0028-B Full Motion TV Wall Mount for 42-75 Inches TVs

Safety Caution

Please read this instruction carefully before installation.
If you do not understand these instructions or have doubts about the safety of the installation, assembly or use of this product, please contact us.

• This product is designed for use in wood stud or solid concrete wall.
  • DO NOT install into drywall alone.
• The wall must be capable of supporting five times the weight of the TV and mount combined.
• Incorrect installation may result in product damage or body injury.

WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. For parts shortage or damage, please contact us.

Must Check Before Getting Started

CAUTION: DO NOT install into drywall alone.

Installation Tools (Not Included)

Hardware Included

INSTALLATION INSTRUCTION

If you have any questions, please feel free to contact us via Amazon.

Warm Tips: You could also refer to the Video Guide about installation on our product page.

1. Select TV screw diameter: Thread screws by hand into the threaded holes on the back of your TV to select which screw diameter fits your TV.

2. Select TV screw length: When attaching brackets to the flat screen, be careful not to over tighten screws and be sure that screws do not bottom out in the mounting holes.

3. Attach the bracket
   CAUTION: Ensure bracket is securely fastened before moving on to the next step.

4. For Flat Back

5. For Round Back / Extra Space
   

Wall plate installation (wood stud)

1. Locate your studs. Verify and mark the center of the studs by finding the stud edges using an awl, a thin nail, and an edge-to-edge stud finder.

2. Position the mounting template at your desired height and line up the holes with your stud center line. Level the mounting template and mark the pilot hole locations.

3. Drill pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
   IMPORTANT: Pilot holes must be drilled to a depth of 2 3/4 in (70 mm). Be sure to drill into the center of the stud.

4. To prevent the TV falling down, the Arrow Must Keep UP at this step!

5. Use the included wrench 05 when have not socket wrench in hand.

6. Install wall plate 01 using lag bolts A with Socket Wrench, NO Electrodrill. Tighten the Alag bolts until they are pulled firmly against the wall plate 01 .

Wall plate installation (concrete)

• Position the mounting template at your desired height , level the mounting template and mark the pilot hole locations x4.
• To prevent the TV falling down, the Arrow Must Keep UP at this step!!
• Use the included wrench when have not05 socket wrench in hand.
• Install wall plate 01 using lag bolts A and anchor (not included) with Socket Wrench, NO Electrodrill. Tighten the lag bolts until they are pulled firmly against the wall plate .

Install front support and extensions

• Install the extensions 03 to front support 02 with the pre-assembled screws.
• Hang 02 onto 01 and using a screwdriver to secure with pre-assembled screws and washer .

Hang TV with brackets onto the arm extensions

Adjustments

Tilting Adjustment

• Tilting: Tilting Angle Adjustment (+5° / -13°) Loosen 2 tilting bolts, pull TV to your desired angle, then fasten tilting nuts with open-end wrench.

TV leveling adjustment (-3°/+3°)

• Loosen 2 leveling bolts on the rear of TV plate with the open- end B wrench , adjust to level, and retighten to secure.

Product dimensions

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>