CHAMPION 200991 Dual Fuel Inverter Generator User Guide
- June 12, 2024
- Champion
Table of Contents
CHAMPION 200991 Dual Fuel Inverter Generator
DANGER
MOVE GENERATOR OUTDOORS
Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains
carbon monoxide. This is a poison you cannot see or smell.
NEVER use inside a home or garage, EVEN IF doors and windows are open.
ONLY use OUTSIDE and far away from windows, doors, and vents.
WARNING
Read the ENTIRE operator’s manual to become familiar with the features of
this product before operation. This QuickStart Guide IS NOT a substitute for
the Operator’s Manual.
Failure to operate the product correctly could result in damage to the
product, personal property or cause serious injury or death.
NOTICE
Keep all objects at least 5 feet (1.5 m) from generator. Heat from the
muffler and exhaust gas can ignite combustible materials.
PARTS INCLUDED
SET UP
Shipping Support. Assembly > Remove Shipping Support Hardware.
Connect the battery. Assembly > Connect the Battery.
Push two halves of battery connector together tightly.
Add oil. Assembly > Add Engine Oil.
Recommended: 10W-30, up to 16.9 fl. oz. (500 ml) DO NOT overfill.
Move the generator outdoors.
ONLY USE OUTSIDE AND FAR AWAY FROM WINDOWS, DOORS, AND VENTS.
Add fuel – Gasoline or Propane (LPG)
Assembly > Add Fuel
DO NOT plug in any electrical devices.
NEVER START OR STOP THE GENERATOR WITH ELECTRICAL DEVICES CONNECTED OR TURNED
ON!
Starting the Engine: Gasoline
Electric Start
- Turn the EZ Start Dial to the “CHOKE” position.
- Press and hold ignition switch on the EZ Start Dial.
- Turn the EZ Start Dial to the “RUN” position.
Manual Start
- Turn the EZ Start Dial to the “CHOKE” position.
- Pull the recoil to start the engine.
- Turn the EZ Start Dial to the “RUN” position.
START UP
Starting the Engine: Propane (LPG)
Electric Start
- Open the propane tank valve.
- Turn the EZ Start Dial to the “CHOKE” position.
- Press and hold the ignition switch on the EZ Start Dial for 2-3 seconds.
- Turn the EZ Start Dial to the “RUN” position.
- Press and hold ignition switch on the EZ Start Dial.
Manual Start
- Open the propane tank valve.
- Turn the EZ Start Dial to the “CHOKE” position.
- Pull the recoil 2-3 times to prime the engine.
- Turn the EZ Start Dial to the “RUN” position.
- Pull the recoil to start the engine.
Plug in. Operation > Connecting Electrical Loads.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>