CHAMPION POWER EQUIPMENT 201223 4000W TRI Fuel Portable Generator User Guide
- May 15, 2024
- CHAMPION POWER EQUIPMENT
Table of Contents
MODEL Nº: 201223
4000W TRI-FUEL PORTABLE GENERATOR
QUICK START
GUIDE
PARTS INCLUDED
DANGER
MOVE GENERATOR OUTDOORS.
Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains
carbon monoxide. This is a poison you cannot see or smell.
NEVER use inside a home or garage, EVEN IF doors and windows are open.
ONLY use OUTSIDE and far away from windows, doors, and vents.
WARNING
Read the ENTIRE operator’s manual to become familiar with the features of this
product before operation. This QuickStart Guide IS NOT a substitute for the
Operator’s Manual.
Failure to operate the product correctly could result in damage to the
product, personal property or cause serious injury or death.
NOTICE
Keep all objects at least 5 feet (1.5 m) from generator. Heat from the
muffler and exhaust gas can ignite combustible materials.
SET UP
-
Attach wheel kit. Assembly > Install the Wheel Kit
-
Connect the battery. Assembly > Connect the Battery.
Cut cable tie on each side of battery connector.
Push two halves of battery connector together tightly.
-
Add oil. Assembly > Add Engine Oil.
Recommended: 5W-30, up to 20.3 fl. oz. (600 ml). DO NOT overfill.
-
Move the generator outdoors.
ONLY USE OUTSIDE AND FAR AWAY FROM WINDOWS, DOORS, AND VENTS.
START UP -
Add fuel – Gasoline or Propane (LPG), or Natural Gas (NG) Assembly > Add Fuel
FOR GASOLINE OPERATION: DO NOT USE E15 OR E85
-
DO NOT plug in any electrical devices.
NEVER START OR STOP THE GENERATOR WITH ELECTRICAL DEVICES CONNECTED OR TURNED ON! -
a
Starting the Engine: Gasoline – Electric Start
1.Turn fuel select dial to “GASOLINE ON” position
2. Move choke lever to “CHOKE” position.
3. Press and hold the ignition switch to the “START” position.
4. Move the choke lever to the “RUN” position.
7b.
Starting the Engine: Propane (LPG) and Natural Gas – Electric Start
1. Open the propane tank or natural gas valve.
2. Turn fuel select dial to “PROPANE ON” or “NATURAL GAS ON” position.
3. Move the choke lever to “CHOKE” position.
4. Press and hold the ignition switch to the “START” position for 2-3
seconds.
5. Move the choke lever to the “RUN” position.
6. Press and hold the ignition switch to the “START” position.
If engine does not start, wait 10 seconds, then repeat step 6.
- Plug in. Operation > Connecting Electrical Loads.
Visit our YouTube channel to watch our how-to videos and subscribe to view our latest videos on our Champion Power Equipment products!
1•877•338•0999
CHAMPIONPOWEREQUIPMENT.COM
TAKEYOURGENERATOROUTSIDE.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>