In Common Augustus Surface Mount Light Instruction Manual
- June 12, 2024
- In Common
Table of Contents
In Common Augustus Surface Mount Light
Product Information
The Augustus Surface Mount is a lighting fixture that can be installed on walls or ceilings. It comes with various components including a backplate, canopy cover, wago clips, G9 LED bulb, diffuser, mounting screws, glass holder, set screws, and surface shade. The fixture requires an electrical power source to operate.
Product Usage Instructions
To install the Augustus Surface Mount, follow these steps:
- Before starting the installation, ensure that you have received all the components mentioned in the guide. Contact us if any component is missing.
- Turn off the electrical power source at the main fuse box or circuit panel.
- Using a Phillips head screwdriver, mount the backplate (Part A) to the junction box by tightening the mounting screws (Part G).
- Use the provided wago clips (Part C) to connect the fixture’s wires to the corresponding wires from the junction box. Ensure proper connections: white for neutral, black for live, and green/yellow for ground. If needed, strip 3/8 of insulation from each wire using a wire stripper before inserting them into the wago clips.
- Align the holes of the backplate (Part A) with the holes of the canopy cover (Part B) and secure them using the set screws (Part H).
- Slide the surface shade (Part I) up the socket and attach it to the backplate (Part B) by rotating the glass holder (Part G) until all components are fixed in place.
- Insert the G9 LED bulb (Part D) into the socket of the shade assembly.
- Screw the diffuser (Part E) into the glass holder (Part G).
- Finally, turn the power back on at the main fuse box or circuit panel.
Please ensure that you follow all safety precautions mentioned in the user manual. If you have any questions or concerns, feel free to reach out to us for assistance.
How to Install Your New Light
Please check that you received all of the components pictured in this guide.
Reach out to us if anything is missing. It’s very rare, but it happens. Don’t
forget to turn off the electrical power source.
Tools you will need that aren’t included: standard wire stripper, Phillips
head screwdriver.
CAUTION
Electrical shock risk. Turn off electrical power at the main fuse box or
circuit panel before beginning installation, servicing the light, or
installing accessories. We recommend working with a qualified electrician
familiar with the type of work you’d like done.
Contents
Installation
- Step 1: Turn off electrical power at the main fuse box or circuit panel before beginning installation.
- Step 2: Mount the backplate (A) to the junction box using a phillips head screwdriver to tighten the mounting screws (G)F
- Step 3: Use the wago clips (C) to connect the fixture’s wires to the corresponding wires from the junction box in the wall or ceiling. White is neutral; Black is live; Green/ Yellow is ground. One ground wire will be attached to the backplate (A), the other ground wire should come from the junction box. If needed use a wire stripper to remove 3/8” of the insulation from each wire before inserting them into the corresponding wago clip.
- Step 4: Align the holes of the backplate (A) with the holes of the canopy cover (B) and secure the set screws.
- Step 5: Carefully slide the shade (J) up the socket. Attach shade (I) to backplate (B) by rotating glass holder (H) until components are fixed in place.
- Step 6: Insert lightbulb (D) into the socket of the shade assembly.
- Step 7: Screw the diffuser (E) into the glass holder (G). Turn the power back on at the main fuse box or circuit panel you disabled before installation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>