Hunter 19940 Holly Grove 2 Light Vanity 18 inch Owner’s Manual
- June 9, 2024
- Hunter
Table of Contents
Hunter 19940 Holly Grove 2 Light Vanity 18 inch
Here are the tools you’ll need to complete your installation
- Ladder
- Screwdriver
- Pliers
- Wire Strippers
OVERVIEW
Hardware Service Kit
INSTALLATION INSTRUCTIONS
WARNING
-
To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box
associated with the wall switch location. -
The lighting fixture must be grounded. If the ground wire for the installation site is not present, immediately STOP installation and consult a
qualified electrician. -
All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a
qualified electrician.
READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. It is very important that
they are read carefully and completely before beginning the installation of
the lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the old fixture from the wall, including the old mounting bracket. Remove the new mounting bracket assembly from the bag. Then remove cap nuts (D) from mounting screws (C). Place the mounting plate (A) over the junction box so that mounting screws (C) and nuts (K) extend out away from the wall. Depending on the placement of your junction box the position of mounting screws (C) may need to be adjusted to allow the backplate to be flush with the wall. Adjust the position of mounting screws (C) so that mounting screws (C) can be exposed 5-6 mm after passing through the backplate (F) to properly fit the cap nuts. Mounting screws (C) can be adjusted by loosening nuts (K) and loosening or tightening mounting screws (C). Once the ideal position of mounting screws (C) has been confirmed, tighten nuts (K) on mounting screws (C) on the front of the mounting plate to ensure that mounting screws (C) are secure. Pull the house wires through the center of the mounting plate (A). Secure the mounting plate (A) to the junction box by tightening the screws (B).
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach
the fixture’s wires to the power supply wires from the junction box. Connect
black to black (live); white to white (neutral); grounding to grounding (green
or copper). Twist the ends of the wire pairs together. Then, twist on a wire
connector. Make sure all twists are in the same direction. Loop the fixture’s
ground wire around the grounding screw (E) and tighten it. If there is no
ground wire (green or copper) from the junction box, contact a qualified
electrician.
FINISHING THE INSTALLATION
Place the fixture’s backplate (F) over the mounting screws (C) so the threads protrude through the holes on the front of the backplate. Tightly screw the cap nuts (D) onto the mounting screws (C) until the backplate (F) of the fixture is snugly against the wall. Slide the cover (G) over the threaded post (L) on one end of the fixture and secure it with finial (H). Install light bulbs (not included) in accordance with the fixture’s specifications. Do not exceed the recommended wattage. Place the glass shade (J) over the sockets sliding the end into the secured cover (G). Install the remaining cover (G) and secure it with finial (H). Turn on the power and test the fixture. Your installation is now complete.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep
cleaning. For regular cleaning, turn off the light and wipe down the fixture
with a clean lint-free cotton or microfiber cloth. Never spray the cleaner
directly onto the fixture.
WARNING FRAGILE GLASS
To prevent chipping/breaking of glass, do not overtighten screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>