IIIF150 Air1 Ultra Plus Smartphone User Manual

Airl Ultra+
User Manual

Please read this guide carefully before use and keep it for future use.

For your safety

Please read this manual before using the cell phone to ensure your safety and proper use.

SWITCH OFF IN HOSPITALS
Please abide by relevant provisions and regulations. Please turn off when Is near medical equipment.
SWITCH OFF WHEN REFUELING
Don’t use the phone at a gas station. Don’t use near fuel or chemicals.
OUT OF CHICDREN’S REACH
Keep your phone, phone parts and accessories out of childrentis reach.
BATTERY
Please do not destroy or damage the battery, It can be dangerous and cause fire. Please do not throw battery in fire to avoid hazard. When battery cannot be used, please dispose in safe environment. Do not try to dismantle the battery. If the battery or authorized charger Is broken or aging , please stop using them, and replace with certified genuine battery.
USE QUALITY EQUIPMENT
Use authorized equipment to avoid danger.
ROAD SAFETY COMES FIRST
Give full attention while driving, park before using your phone. Please follow local traffic rules.
INTERFERENCE
All wireless devices may to cause Interference, which could affect performance.
SWITCH OFF IN AIRCRAFT
Wireless devices can cause interference against aircraft Its not only dangerous but also illegal to use mobile phone in en aircraft.
ONE SIM NEEDLE

Learn about the phone

Overview

1 Card Tray
2 II1F150 Key
3 Light Sensor
4 Receiver
5 Front Camera[32M)
6 Touch Screen
7 Microphone
8 Headset/USB interface
9 Waterproof test hole| 10 Volume Key
11 Power Fingerprint/ Key
12 Photo Flashlight
13 Rear Camera(64M)
14 Pickup Lights
15 Infrared Thermometer
16 Infrared Lamp
17 Night Vision Camera(24 NI)
18 Speaker
---|---

Function Keys

off the phone.
VOLUME KEY| Press to adjust the volume of device.
HOME KEY (ON THE SCREEN)| Tap to return to Home screen.
BACK KEY (ON THE SCREEN)| Tap to return to the previous screen.
FINGERPRINT KEY| Press to unlock the phone.
II1F150 KEY(SOS)| Click 5 times to enter SOS mode.

Before using

The phone is a Dual SIM mobile that allows you to use two mobile networks.

• Insert SIM cards and TF card
• Plug-free design, take out the sim tray without any tool.

Insert the Nano SIM cards and TF card to the card slots correctly.
Card 1 supports Nano SIMI card.
Card 2 supports Nano SIM2 card or TF card.

Note:

1. Do not remove the cards while the device is transferring data. It so may cause data to be lost or damage to the cards and device.
2. The SIM cards and TF card are small parts. Please keep away from children to avoid accident.
3. Please do not touch the metal surface of SIM and TF cards and keep them away from electromagnetic field to avoid data damaging

• Charge the Battery
Charge the battery before using it.

Getting started

• Basic Function

1. Turn on the phone Press and hold the power key for a while to turn on the phone.

2. Turn off the phone Long press the power key until a menu shows. Choose “Power off ” to turn off the phone.

3. Restart the phone
   Option 1: Long press the power key until a menu shows. Choose “Reboot” to restart the phone.
   Option 2: Long press the power key till 13-15 seconds to auto restart the phone automatically.

4. Lock the screen
   Option 1: Press the power key to turn off the screen and lock it.
   Option 2: The screen will auto lock if you don’t use the phone for a while.

5. Unlock the screen Press the power key for unlocking.

Warnings and notes

• Operational Warnings
  Important Information on safe and efficient operation. Read this information before using your phone. For the safe and efficient operation of your phone, observe these guidelines:

• Potentially Explosive at Atmospheres:
  Turn off your phone when you are in any areas with a potentially explosive atmosphere, such as fueling areas (gas or petrol stations, below deck on boats), storage facilities for fuel or chemicals, blasting areas and areas near electrical blasting caps, and areas where there are chemicals or particles (Such as metal powders, grains, and dust) in the air.

• Interference to Medical and Personal Electronic Devices:
  Most but not all electronic equipment is shielded from RF signals and certain electronic equipment may not be shielded against the RF signals from your phone.

• Audio Safety:
  This phone is capable of producing loud noises which may damage your hearing. When using the speaker phone feature, it is recommended that you place your phone at a safe distance from your ear.

• Other Medical Devices, Hospitals:
  If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from external RF energy. Your physician may be able to assist you in obtaining this information. Turn your phone OFF in health care facilities when any regulations posted in these areas instruct you to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF energy.

• Product Statement on Handling and Use:
  You alone are responsible for how you use your phone and any consequences of its use.
  You must always switch off your phone wherever the use of a phone is prohibited. Use of your phone is subject to safety measures designed to protect users and their environment. Always treat your phone and its accessories with care and keep it in a clean and dust-free place. Do not expose your phone or its accessories to open flames or lit tobacco products. Do not expose your phone or its accessories to liquid, moisture, or high humidity. Do not drop, throw, or try to bend your phone or its accessories. Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its accessories. Do not attempt to disassemble your phone or its accessories; only authorized personnel can do so. Do not expose your phone or its accessories to extreme temperatures, minimum -4 Rind maximum 158’F(-20°C to 70t).

• Battery:
  Your phone includes an internal lithium-ion or lithium-ion polymer battery. Please note that use of certain data applications can result in heavy battery use and may require frequent battery charging. Any disposal of the phone or battery must comply with laws and regulations pertaining to lithium-ion or lithium-ion polymer batteries.

• Faulty and Damaged Products:
  Do not attempt to disassemble the phone or its accessory. Only qualified personnel can service or repair the phone or its accessory. If your phone or its accessory has been submerged in water, Punctured, or subjected to a severe fall, do not use it until you have taken it to be checked at an authorized service center.

• Safety Information
  Do not use the mobile phone in the environment at too high or too low temperature, never expose the mobile phone under strong sunshine or too wet environment. The maximum operating ambient temperature of the equipment is 70 C.
  Excessive sound pressure from earphones and headphones can cause hearing loss. To prevent possible hearing damage, do not listen at high volume levels for long periods.
  Waste Electrical and Electronic Equipment (WEE)
  This symbol means that according to local laws and regulations your product and/or its battery shall be disposed of separately from household waste. When this product reaches its end of life, take it to a collection point designated by local authorities. Proper recycling of your product will protect human health and the environment.

FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including Interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no 8 guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: OReorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected. OConsult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions accepted by the FCC with the phone transmitting at Its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the phone white operating can be well below the maximum value. Before a new model phone Is a available for sale to the public, it must be tested and certified to the FCC that It does not exceed the exposure limit established by the FCC, tests for each phone are performed in positions and locations as required by the FCC. For body worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an acoessory designated for this product or when used with an accessory that contains no metal and that positions the handset a minimum of ianm from the body. Non-compliance with the above restrictions may result in violation of RF exposure guidelines. FCC ID: 2A8X4-AIMULTRAPRO

• Accessory Information
  Battery: 7000mAh Typical All software versions released by the manufacturer have been verified and are still compliant with the related rules.

• Warning
  1. Use careful with the earphone maybe possible egos salve sound pressure from r arphones and headphones can cau* hearing loss.
  2. CAUTION: RISK CF EXPLOSION F BATTERY IS REPLACED BYAN NCORRECT TYPE. DISPOSE C F USED BATTERIES ACCCFINGTO TM: INSTRUCT1P4S,

3. The product sin ill only be connected toe UM Interlace of version USB2.O.
4. Adapter shat bo instaled new the equipment and ES .al be eerily accessible.
5. Operation temreraturec-20-70°C.
6. The plug consic wed as disconnect device of adapt w.
7. SAR: The device complies with RF specifications whin the device used at 0.5cm from gar body (SAR limit 20 VI/Kg). The devi :e isin compliance with the recars meets.

• Restrictions in the 5 GHz Band:
  According to Article 10 (10) of Directive 2014/53/EU, the packaging shows that this radio equipment will be subject to some restrictions when placed on the market in Belgium CBE), Bulgaria CBG), the Czech Republic CCZ),Denmark (DIG, Germany (DE), Estonia CEO, Ireland CIE), Greece CEL), SpainCES), France CFR), Croatia CHR), Italy CIT), Cyprus CCY), Latvia CLV), LithuaniaCLT), Luxembourg (LU), Hungary CHU), Malta CMT), Netherlands (NL), AustriaCAT), Poland CPO, Portugal CPT), Romania CR0), Slovenia MI), Slovakia CSIC,Finland CFI), Sweden CSE), Turkey CTR), NorwayCNO), Switzerland CCH), Iceland CIS), and Liechtenstein CLI). The VVLAN function for this device is restricted to indoor use only when operating in the 5150 to 5250 MHz frequency range.

How to set the IIFI60 RGB Rhythm Light?

Steps:
1 Click Settings

2 Click IIP160 Lights
3 Tum ON the Rhythm Lights swicth and Click the Rhythm Lights
4 Choose the Mode you like
Note:
A. There are three flashing modes to be offered. The Rhythm light will flash randomly when playing music or video.
2. If the Rhythm Light cannot works when you play music or video, please check the following settings:
4 Please check whether you have Turn ON the Rhythm Light
2 Please check if the time you play music of video is between the start time and the end time you set.
3 Please check if you Turned ON the Do Not Disturb mode ar Power Saving mode.
4 When the phone’s battery is lower than JO%, the Rhythm light will automatically turn off.
5It it still cannot work after all setting above is correct, please try to restart your smartphone.
How to set the ilIF1S0 Breathing/Notification LED?
Stepa:
Click Settings
2 Click SIPASO Lights
Tum ON the Breathing[Natification) LED and Click it
4 Chooee the color of LED you like and choose the apps you need ta be notified when receiving an incoming calls or messages.
Note:
4. The Breathing LED will work vehen you recelved an Incoming call or a message/notification.
2, The LED will not ight up when you are using the camera, even If you set the standard mode(alweays light on).
3. The breathing LED will stop after S minutes of operation until a new message/notification comes,
4 If the Breathing(Notification) LED will not light up, please check whether the following setting is correct or not:
Please check whether you have Turn ON the Breathing(Notitication) LED
2 Please check if the time you received incoming calls or messages/noti- fications is between the start time and the end time you set.
3 Please check whether you have Tum ON the Power saving mode and Do not disturb mode,
4 When the phone’s battery is lower than 30%, the MIFI60 light (Rnythm light & Breathing light) will automatically turn off.
5 Please check if the Apps you need to be notitied when receiving messages are set as “Support notification Light effect”, you can check it in the following wat Settings>IlIF 150 Lights» Breathing LED>Apps supporting notification light effect.
Tips:
Please Tur ON the Standard Mode when you choose the color of LED, so you can check how It looks Ike directly. After you finish the setting, you can choose to Tum It ON/OFF to make the light always on/off.
How to set the 120Hz Refreshing Rate?
>4 Click Settings
2 Dieplay
3 Advanced
4 Screen Refresh Rate
5 Chooee the refresh Rate you prefer

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>