Pro-Ject Tristand Loudspeaker User Manual

June 12, 2024
Pro-Ject

Tristand
User Manual

Tristand Loudspeaker

Size without feet (W x D x H): 328 x 328 x 678 mm
Size with feet (W x D x H): 328 x 328 x 700 mm
Top plate surface (W x D): 150 x 142 mm
Weight per Tristand: 5 kg
Maximum load per Tristand: 20 kg
Before assembly please make sure all parts are included.

Step 1
As shown in the picture below, take the top plate and one of the two steel proles marked with no. 1 and attach them together. Screw the top plate and steel prole together (using a M4x14 screw and the included Allen key), but do not tighten the screw completely yet.

Pro Ject Tristand Loudspeaker - Product Overview 1

Pro Ject Tristand Loudspeaker - Product Overview 2

Step 2
Take another steel prole now with mark no.2, and attach it in the opposite direction to the previous one into the hole above the rst steel prole (as shown in the picture below). Don’t tighten the screws completely.

Pro Ject Tristand Loudspeaker - Product Overview 3

Pro Ject Tristand Loudspeaker - Product Overview 4

Step 3
Repeat step 2 with another steel prole.

Pro Ject Tristand Loudspeaker - Product Overview 5

Step 4
Repeat step 1 with another steel prole marked no. 1 in the same direction as in step 1.

Pro Ject Tristand Loudspeaker - Product Overview 6

Step 5
Take the base plate and put it on the steel proles from the other side. Align the threads with the holes in the base and screw them together. At rst don’t tighten the screws completely. Once you have all screws in the threads, tighten them. Afterwards, also tighten the screws on the top plate (steps 1 ­ 4).

Step 6
Screw the nuts onto the spike feet.
Then screw the feet into the base. Carefully lift the assembled Tristand up, place it on the ground and put the cups under the spike feet. You can now tighten or loosen the spike feet to ensure the base is level (use a spirit level if necessary).

Pro Ject Tristand Loudspeaker - Product Overview 8

Step 7
Now you are ready to place the speaker on the Tristand. You have two options on how to do that.

  1. Directly place the speaker onto the microporous rubber pads on top plate.
  2. Screw the M5x20 spikes into the threads located in the middle of the microporous rubber pads. Adjust the height until the speaker has a proper stand and lock the screw with a nut from the bottom.

Pro Ject Tristand Loudspeaker - Product Overview 9

Pro-Ject Audio Systems is a division of Audio Tuning Vertriebs GmbH Margaretenstrasse 98, A-1050 Vienna, Austria

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals