phrozen T11364 Air Purifier User Guide

: June 12, 2024
: phrozen

Table of Contents

phrozen T11364 Air Purifier
Product Information
Product Usage Instructions
Introduction
Product Specifications
User Guide
Read User Manual Online (PDF format)
Download This Manual (PDF format)

phrozen T11364 Air Purifier

Product Information

Model : X4
Type : 3D Printer
Compliance : SJ/T11364

The X4 is a 3D printer that comes with plastic parts, metal parts, a circuit board assembly, cables, and wires. It is compliant with the SJ/T11364 standard, ensuring the safety and quality of the product.

Product Usage Instructions

Unpack the X4 3D printer and place it on a stable and flat surface.
Check all the components to ensure nothing is damaged during transportation.
Connect the power cable to the printer and plug it into a suitable power outlet.
Turn on the power switch located on the printer.
Install the necessary software on your computer by following the provided instructions.
Connect the X4 printer to your computer using the provided USB cable.
Launch the software and follow the on-screen instructions to set up the printer and configure the printing parameters.
Prepare the print bed by cleaning it and applying a suitable adhesive if required.
Load the desired filament material into the printer’s filament holder.
Insert an SD card with the 3D model file into the designated slot if applicable.
Select the desired 3D model from the software and click on the print button to start the printing process.
Monitor the printing progress and ensure that there are no errors or issues.
Once the printing is complete, carefully remove the printed object from the print bed.
Turn off the printer and disconnect it from the power source.
Clean and maintain the printer according to the provided instructions to ensure its longevity.

Dear User Thank you for joining us. Please read the manual thoroughly and follow the instructions step-by-step to get the best printing experience.

Introduction

Product Specifications

Product Size 115 × 46 × 46 mm
Activated Carbon Filter Size | 39 × 39 × 18 mm
Battery Capacity | 2000 mAH
Input| DC 5V
Power | 0.6W

User Guide

Remove the top cover of the air purifier and take out the activated carbon from its plastic packaging, then fasten the cover.
Charge the device with a type-C cable. The light will flash during charging and goes off when it is sufficiently charged.
Turn on the air purifier and check the green light before placing it inside the plastic case of your 3D printer.

Light On : On
Light Flashing : Charging,
Light Off : Low battery

NOTICE
Please remove the plastic packaging of the activated carbon filter before use.

Replace the activated carbon filter every 3-6 months for the best result.
DO NOT turn on the air purifier when it’s charging to avoid damaging the unit.
Keep the device and its accessories out of reach of children.
Dry the used carbon in the sun or a well-ventilated place to dissipate the smell.

This table is made according to SJ/T 11364.

O : Indicates that the concentration of hazardous substance in all of the homogeneous materials for this part is below the limit as stipulated in GB/T 26572.
x : Indicates that the concentration of hazardous substance in at least one of the homogeneous materials used for this part is above the limit as stipulated in GB/T 26572.

Phrozen 3D Printer phrozen3d.com ‹ +43-1-997809410/+886-3-5400076 2 3F., No. 287, Niupu. Rd., Hsinchu City 30091, Taiwan

APEX CE SPECIALISTS LIMITED
Unit 3D North Point House, north Point Business Park, New Mallow Road, Cork, T23 AT2P, Ireland