Goldair GCV380 Electronic Convector Heater Instruction Manual

Goldair GCV380 Electronic Convector Heater

General Care and Safety Guide

YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they are supervised or have been given instruction concerning the use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.
  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• WARNING: You must not cover this appliance. Covering this appliance presents fire risk and will activate the safety fuse; permanently disabling the unit.
  WARNING: Do not use this appliance in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
  WARNING: To reduce the risk of fire, keep textiles, curtains, or any flammable material a minimum distance of 1 metre from the air outlet.

  • Use only the voltage specified on the rating label of the appliance.
  • Keep all objects at least 1 metre from the front, sides and rear of the appliance.
  • This appliance is intended for household use only and not for commercial or industrial use.
  • Indoor use only.
  • Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock or injury.
  • Do not use the appliance if it has been dropped or damaged.
  • The common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills.

• Never use the appliance to dry clothes.

  • Always unplug appliance when not in use.
  • When the appliance has been unpacked, check it for transport damage and ensure all parts have been delivered. If parts are missing or the appliance has been damaged, contact the Customer Services Team.
  • Do not use if there are visible signs of damage to the appliance.
  • Do not connect the appliance to mains supply until completely assembled and adjusted.
  • Ensure hands are dry before handling the plug or main unit.
  • Ensure appliance is on a flat, stable, heat-resistant surface.
  • Do not operate with cord set coiled up as a heat build up is likely, which could be sufficient to become a hazard.
  • Carry out regular checks of the supply cord to ensure no damage is evident
  • Do not operate this appliance with a damaged cord, plug or after the appliance malfunctions or has been dropped or damaged in any manner. Take to a qualified electrical person for examination, electrical service or repair.
  • Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and split. Always ensure that all cord has been removed from any cord storage area and is unrolled before use.
  • It is recommended that this appliance is plugged directly into the wall socket. Power boards are not rated to supply power to high wattage appliances.
  • A correctly specified, undamaged extension cord may be used with this appliance provided it is used in a safe manner.
  • Do not remove plug from power socket until the appliance has been switched off.
  • Do not remove plug from power socket by pulling cord; always grip plug.
  • Do not place cord under carpet or cover with rugs or furniture. Arrange the cord so it cannot be tripped over.
  • Don’t place appliance on bedding or on thick & long carpet where the openings may get blocked.
  • Switch off and use handle provided when moving
  • Do not place appliance close to radiant heat source.
  • Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock, fire or damage to the appliance.
  • Do not sit on the appliance.
  • Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) rinsed in hot soapy water only.
  • Always remove plug from the mains supply before cleaning.
  • Do not operate in areas where petrol, paint or other flammable liquids are used or stored.
  • Do not use this appliance in the immediate surrounds of a bath, a shower, or a swimming pool or other liquids.
  • The appliance must not be immersed in any liquids.
  • There are no user serviceable parts installed in the unit.
  • Do not place the unit in wardrobes or other enclosed spaces as this may cause fire hazards.
  • This unit is not supposed to be used in or around locations where foodstuffs, works of art or delicate articles of science, etc. are stored.
  • If your appliance does not work, or is not working properly, contact the place of purchase or the Customer Services Team.

• The remote control supplied with this appliance uses a CR2025 coin type battery.

• DANGER IF SWALLOWED

  • Keep batteries out of reach of children. Swallowing may lead to serious injury or death in as little as 2 hours due to internal burns.
  • If swallowed, go straight to a hospital emergency room.
  • Dispose of used batteries immediately.

• WARNING!

  • DANGER IF SWALLOWED
  • Keep batteries out of reach of children. Swallowing may lead to serious injury or death in as little as 2 hours due to internal burns.
  • If swallowed, go straight to a hospital emergency room. Dispose of used batteries immediately.

Components

WARNING: Heater must not be used without the castors fitted.

Assembly Instructions

WARNING: Heater must not be used without the feet fitted.
This appliance has been supplied with ‘1 way screws’ for permanent installation of the feet. This is a safety requirement for the New Zealand and Australian market.

ASSEMBLY FOR FREE STANDING
PLEASE NOTE: The screws supplied are one way screws so once screwed in they cannot be unscrewed again.
Each castor plate supplied with this heater (supplied separately in the carton) requires 3 screws to attach them securely to the heater. Holes are pre-drilled in the base of the heater. The castor plates come with 3 pre- drilled holes.

1. Carefully turn the Main Body upside-down on a scratch-free and stable surface. Be careful to prevent damage to the cosmetic finish or your floor surfacing.
2. Place the plastic lugs on the castor plate into the holes on the bottom of the heater and secure them in position with small screws provided.

Operating Your Heater

• Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all packaging has been removed from the unit before use. Please follow the below instructions.
  • WARNING: In order to avoid overheating or fire, do not cover the heater.
  • WARNING: Keep all objects at least 1 metre from the front, sides and rear of the appliance.
  • WARNING: Do not use this heater with a programmer, separate timer, remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
  • WARNING: Never leave this heater unattended when in use.
• Ensure heater is on a flat, stable, heat-resistant surface.
• Once the heater is in a safe operating position and all switches are in the off position, insert the power plug into the mains outlet and switch on.
  • CAUTION: Ensure the power cord is not tight because if pulled it may partially pull the plug from the socket. A partially inserted plug will overheat the plug and socket and could result in fire.
  • Note: When the appliance is turned on for the first time, it may release a slight odour or smoke. This odour or smoke is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again.
• Press the main power button on the right hand side of the heater. The heater will beep.

CONTROL PANEL

• ON/OFF

  • Press this button on the display to switch the heater on and off.
  • When switched on it will show the ambient room temperature.
  • The default heat setting is high.

• Thermostat

  • The default setting is 25oC. Press the ‘+’ or ‘-’ buttons on the screen to adjust to your desired temperature from 15-32oC. Once set the heater display will return to showing the ambient temperature.
  • The heater will automatically switch between high and low power and off to achieve and maintain this setting.
  • When the heater is in high power, press the ‘-‘ button for 3 seconds to select low power.
  • When the heater is in low power, press the ‘+’ button for 3 seconds to select high power.

• Timer Off
  When the heater is on, press the timer button to set the delay timer from 0-15 hours. Once the time has elapsed the heater will turn off.

• Timer On
  When the heater is off, press the timer button for 3 seconds to activate the timer. Then keep pressing the button to set the delay timer from 0-15 hours. Once the time has elapsed the heater will turn on.

REMOTE CONTROL

•  Press this button to switch the heater on and off.

•  Use these buttons to decrease or increase the set temperature.

• Power Selection: High Power / Low Power

• Timer Off

  • When the heater is on, press the timer button then use the ‘+’ & ‘-’ buttons to set the delay timer from 0-15 hours.
  • Once the time has elapsed the heater will turn off.

• Timer On

  • When the heater is off, press the timer button for 3 seconds to activate the timer, then use the ‘+’ & ‘-’ buttons to set the delay timer from 0-15 hours. Once the time has elapsed the heater will turn on.

  • The remote control uses a CR2025 coin type battery.
    WARNING!

  • DANGER IF SWALLOWED

  • Keep batteries out of reach of children. Swallowing may lead to serious injury or death in as little as 2 hours due to internal burns.

  • If swallowed, go straight to a hospital emergency room.

  • Dispose of used batteries immediately.

SAFETY DEVICES

This appliance has two protection devices:

• Resettable Thermal Link – this will automatically disconnect the power to the appliance at a pre-set overheat temperature. After cooling down it will reset and power on again. If this occurs, investigate what is causing the appliance to overheat.
• Thermal Fuse – this disconnects the appliance permanently in case of overheating.(It is non resettable).
  CAUTION: The heater generates heat during use. Precautions must be taken to prevent the risk of burns, scalds, fires or other damage to persons.

CARE AND CLEANING

• The heater requires regular cleaning to ensure trouble free operation:
• Unplug the heater from the mains supply before cleaning.
• Ensure that the heater has been allowed to cool down completely before cleaning.
• The common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are removed regularly by unplugging the appliance and vacuum cleaning the air vents and grills.
• Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
• Never use solutions such as petrol, thinners or polishing agents.
• Ensure the heater is dry before plugging back into the mains supply.
• Do not attempt to dismantle the appliance.
• There are no user serviceable parts. For service or repair, contact an authorised electrical service technician

PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.

TECHNICAL SPECIFICATION

• Model No: GCV 380
• Supply: 220 240 VAC 50 60 Hz
• Wattage: 2000 W

SUPPORT AND TECHNICAL ADVICE

• Goldair – New Zealand
  • Monday – Friday 8am 5pm
  • Phone +64 (0)9 917 4000
  • Phone 0800 232 633
  • info@cdb.co.nz
• Goldair – Australia
  • Monday – Friday 8am 5pm
  • Phone +61 (0)3 9365 5100
  • Phone 1300 465 324
  • info@cdbgoldair.com.au

Two Year Warranty

• Thank you for purchasing this Goldair Select product. Your product is warranted against faults and manufacture when used in normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three months.
• Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.
• This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out by anyone other than a qualified electrical service technician.
• PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
• The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in relation to the goods or services to which this warranty relates.
• In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
• In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).
• Goldair – New Zealand
  • CDB Goldair
  • PO Box 100-707
  • N.S.M.C
  • Auckland
  • Phone +64 (0)9 917 4000
  • Phone 0800 232 633
  • www.goldair.co.nz
• Goldair – Australia
  • CDB Goldair Australia Pty
  • PO Box 574
  • South Morang
  • Victoria, 3752
  • Phone +61 (0)3 9365 5100
  • Phone 1300 GOLDAIR (1300 465 324)
  • www.goldair.com.au

WARRANTY CARD

New Zealand

• PO Box 100707,
• North Shore Mail Centre, Auckland, 0745
• www.goldair.co.nz

Australia

• PO Box 574,
• South Morang, Victoria, 3752
• www.goldair.com.au

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>