OEM K9 Dual Wireless Lavalier Collar Microphones User Manual
- June 12, 2024
- OEM
Table of Contents
OEM K9 Dual Wireless Lavalier Collar Microphones User Manual
Introduction
This product is a smart wireless microphone that provides professional – grade recording output . Plug and play , no app required . Multiple uses : It can be used in online live broadcast , video Vlog shooting , program interview , recording , video teaching and other occasions . he wireless Microphone consists of two parts , one is Microphone transmitter , the other one is receiver . ( See as below picture )
ID Diagram
- Windproof net 7 port to connect phone
- Microphone indicator 8 Receiver indicator
- Microphone charging port 9 Reset key of receiver
- Microphone clip
- Switch key
- Microphone reset key
How to use
Step 1 : Connect the receiver to phone withport
Note : oppo / vivo / iqoo realm brand mobile phones can be used normally
only when they go to the settings
( search ” OTG ” – turn on OTG power supply )
Step 2 : Press switch key of microphone , the indicator light turns green , and then power is turned on .
Step 3 : The indicator red light of receiver keeps always on , then open the phone camera , live App or other Apps , and then to use the microphone to receive sound .
Special Note :
For the use of 1 port there is no battery in receiver , and noneed to recharge
during live . If the phone is low power during
Live , it can be recharged directly through port .
About UI
| Function | How to use | Light |
|---|---|---|
| Power on | Press switch key once | Green light on |
| Power off | Press switch key about |
3 seconds
| Light off
Pairing| | Red and green flash
alternately
Paired| | Green light keeps on
Pause| Press switch key once| The green light flashes
slowly during pause
Reset| Press reset key for
3 seconds
|
Low battery alarm| Power on state| The red and green lights
come on every 1 0 seconds
Charging| Charging with cable| The red light goes out
when it is fully charged
Receiver
| Function | How to use | Light |
|---|---|---|
| Power on | Plug in the device | Red light on |
| Power off | Plug off the device | Light off |
| Pairing | Red light flashes slowty | |
| Paired | Red light on |
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>