Ubiquiti U-POE-AF Gigabit Power Over Ethernet PoE Injector User Guide
- June 12, 2024
- UBIQUITI
Table of Contents
U-POE-AF Quick Start Guide
Package content
hardware description
Installation
- Connect a network cable to the PoE port on the injector and the other end to the Ubiquiti device you want to power (see device specifications).
- Connect a network cable to the LAN port of the injector and the other end to the router or switch de su red local.
- Connect the power cord to the injector and the other end to an electrical outlet. stream.
Mounting the PoE adapter (optional)
- Remove the PoE mounting bracket of the adapter, place the bracket in the desired position and mark the two holes.
- Taladre los agujeros, si fuera necesario, y fije el soporte utilizando dos rivets (not included).
- Align the slots of the adapter with the screws of the PoE mounting support and, then, slide the adapter down.
specs
safety instructions
- Read, follow and save these instructions.
- Pay attention to all warnings.
- Only use the devices or accessories indicated by the manufacturer.
ADVERTENCIA: Superficie caliente. No tocar.
electrical safety information
- It is mandatory to comply with the current, frequency and voltage requirements indicated on the manufacturer’s label. Connection to a power source other than those specified may result in malfunction, equipment damage, or fire hazard if limitations are not followed.
- This equipment contains no operator-serviceable parts. Only a qualified service technician should provide services.
- This equipment is supplied with a detachable power cord that has an integral safety ground wire designed to be connected to a safety ground. a. Do not substitute the power cord with one other than the approved type provided.
Never use an adapter plug to connect to a two-wire outlet, as it will break the continuity of the ground wire.
b. The equipment requires the use of the ground wire as part of the safety
certification. Modification or misuse can create a shock hazard, which could
cause serious injury or death.
c. If you have any questions about the installation, contact a qualified
electrician or the manufacturer before connecting the equipment.
d. The indicated AC adapter provides a safety ground. For installation in a
building, adequate short-circuit back-up protection must be provided.
and. A protective connection must be installed in accordance with national
wiring rules and regulations.
limited warranty
ui.com/support/warranty
The limited warranty requires arbitration to resolve disputes on a case-by-
case basis and, where appropriate, specifying arbitration instead of jury
trials or class actions.
Compliance
FCC
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions.
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide acceptable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense.
CE marked
**** El marcado CE de este producto indica que el producto cumple con todas las directivas aplicables.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>