JYS Alloy Spider Car Instruction Manual

JYS Alloy Spider Car Instruction Manual

Thank you for using our products. In order to get a better understanding of this product, Please read the following instructions carefully before using them, which will bring you a different sense of operatina experience.

Attention

• Elictric control product: This product is suitable for 6 years old and above. It is assembled/charged by adults and then  aye chilaren. the product under the supervision of adults.
• Please do not dismantle or modify the product without authorization. Any modification may cause the product to be unable to be used normally.

Precautions for Use

1. The toy car uses a 7.4V rechargeable lithium battery; the remote controller uses 2X1.5V “AA” unchargeable batteries.
2. Battery removal and loading. should be carried out correctly according to the polarity and voltage in the toy battery box;
3. Uncharged battery not rechargeable; –
4. The rechargeable battery must be charged under adult supervision;
5. The rechargeable battery should be taken out of the toy before charging;
6. Different types of batteries or old and new batteries can’t be used in’mix;
7. The car body must use the original configuration of battery; And the original’ USB cable must be used to charge the battery;
8. The run out of battery should be removed from the toys; If you haven’t used it for a long time, please remove the toy’s battery.
9. The power terminal shall not be short-circuited; K o
10. Use a screwdriver turned on the remote control battery cover screw, across the electrodes in the correct polarity into the battery, use a screwdriver on the battery cover screw drive at the end of the screw, the battery plug wire connected to the body the power cord in the correct polarity;
11. Repair and maintenance: this product is a plastic, hardware and electronic components, shall not enter the water or placed in a humid environment or use for a Iong tlme,regularly check the wires, plugs, casing and other parts for defects and found defects should stop using, and restored.

2.4G Automatic Code Matching Specification

1. The remote controller is.equ[ifaped with a battery, the indicator of the remote controller starts flashin%vand the remote control car is equipped with a battery to open the switch and starts to enter the connection state. When the connection is successful, the indicator of the remote control goes out.
   Note: Please repeat the above operation if the connection is unsuccessful. i o

2. Each remote controller can only be connected with one remote control car. When the connection is successful, each car will not interfere with éach other.Note: When multiple cars are used at the same time, the connections can be opened in turn. X . X

3. When the remote controller is unsuccessful in code alignment, it will go to sleep after 30 seconds. When the code alignment is successful, it will go to sleep after 300 seconds without operation, and any key will wake up.

4. When it is necessary to fiall’ other remote controllers or remote control cars of the same model, it is necessary to take out the battery of the remote controller and turn off the power switch of the remote control car before repairing

Description to the Functions of Remote Control

How to Recharge

1. This 7.4V lithium batter?/ is new, before playing please charge the battery. USB charging cable
2. Plug the battery wire plug into the charger plug according to the correct positive and negative connection, and then plug the charging cable into the socket to charge.
3. It takes 2-3 hour to fully charge the battery, Charging plug with indicator light, red light on when chargin?, light off when full. Please don’t overcharge, Charging for a long time will not increase the power.
4. Checl to(}/s and batteries regularly. If accessories, batteries, charging cables, etc. are damaged, stop using them immediately. After repair or renewal, can continue to use.

How to Install Batteries

Remote controller
Ofen the battery cover of th,e, remote control and load the 1.5 V “AA” b ttery accordilto theiosi ive and negative poles in the battery bin o the remote co trot co partment. cover the battery ox an rock Me screws. (1)F5IroTeornhceoartlycaCover under the car and connect the rechargeable battery Wine power and load it into the bottom of the car. cover the battery box and lock the screws.

Operations of Remote Control and Cars

As shown in the figure, operate the “Forward/ backward” lever, the remote control car forward/ backward.

As shown in the figure, conduct combined rocker operation of “Forward + Left / Right turn”, the remote control car turns to the front left/turns to the front right.

As shown in the figure, operate the “Left/Right turn”, the remote control car left/right rotation.

As shown in the figure, operate the side row key. the remote control car u’pper left/lower right/ remote control carautor;lafic upper right/lower left side « stunt demonstration. row.

As shown in the figure, operate the “Left horizontal move/right horizontal move” key, the remote control car moves to the left/right horizontally.

As shown in the figure, conduct combined rocker Operation of “Backward + Left/Right turn”, the remote control car turns to the back left/ turns to the back right.

As shown in the figure, operate the “Light control”  key, the remote control car opening/closing of the light effect.

As shown in the figure, operate onekey desmonstraition: key the remote control carautor;lafic stunt demonstration.

Instructions

The toy battery charger should be checked before use to prevent damage to wires and other components. If there is damage, it must be repaired before use.

General Fault Handling

Symptoms| Fault cause| Treatment method
The vehicle cannot
be operated|

1. The remote control is not connected or the remote control car switch is not on.
2. The battery is not properly installed.
3. The rechargeable battery is weak.

|

1. Open the car switch, contact the remote control again.
2. Properly load the battery into the remotecontrol and the car.
3. The car battery is charged.

The vehicle is not
controlled and the
distance is close by
remote control|

1. Remote control or car battery,lack of electricity.
2. There may be a source of disturbance near the site.

|

1. Replace the battery in your remote control or recharge your car battery.
2. Replace the site.

Abnormal protection| When the function of the remote control vehicle is hindered by external forces or the power is insufficient, circuit battery short circuit.| Re-tum on the power switchis powered take out the battery and reload it after it s powered off.

T0 consumers

1. When playing with remote control cars indoors, please be careful not to damage furniture or glass.
2. Please play in a safe place outdoors. Don’t play with remote control cars on the road and in crowds, so as to avoid danger.
3. When you hear thunder when playing in a remote control car outdoors, you should stop playing immediately.
4. When the wheels rotate, don’t stretch your hands close to avoid injury, and don’t get involved in hair, clothes, etc.
5. Do not drive the remote control car at people.
6. Do not throw or collide the remote control car.
7. Keep away from fire sources and high temperatures when placing remote control vehicles.
8. This car uses complex electronic circuits and a large number of meta-accessories. Please do not disassemble or modify the circuit board at will.
9. When the remote control car is covered with dirt and dust after playing, it must be gently wiped with a wet cloth.
10. Don’t put the toy in water, it will damage the electronic components.

Warning:

The contained widgets are at risk of suffocation and are not suitable for children ages 3 and under to play with. Adults must be present when using them for supervision and guidance.

• This manual contains important information, which cannot be discarded for inquiry.

FCCID: 2AP5E-JYS2900
This device complles with part 15 of the FCC RulesOperation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)this device must accept any interference received. including interference that may cause undesiredoperation.
Toy RC Xtreme Wall Climber JYS2018

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

IC Caution.
CAN ICES-003(B) / NMB-003(B)

This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>