CRYSTORAMA ORS-734-MG Orson 4 Light Chandelier Instruction Manual
- June 12, 2024
- CRYSTORAMA
Table of Contents
CRYSTORAMA ORS-734-MG Orson 4 Light Chandelier
Product Information
The Crystorama ORS-734-MG is a dry rated lighting fixture that has been lighting the way for sixty years. It requires four candelabra bulbs with a recommended wattage of 40 watts and maximum wattage of 60 watts. LED bulbs are recommended for extended use. This model comes with mounting hardware, including a mounting plate, box screws, ball nuts, and a check ring. The fixture is CSA841804HAMR1 certified but can expose you to lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.
WARNING All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes. You will need 4 – Candelabra Bulb 40 Watts Recommended 60 Watts Max USE LED BULBS FOR EXTENDED USE This fixture is Dry Rated.
Product Usage Instructions
- Turn off the power before installing the fixture.
- Determine the preferred hanging height and choose the correct length of stems needed.
- Slip the wires through the stems and connect them together. Place the check ring over the threaded nipple on top of the fixture body. Screw one end of the stem assembly onto the fixture body and the other end onto the swivel on the canopy.
- Attach the mounting plate to the outlet box using box screws and connect the fixture wires to the supply wires.
- Mount the fixture to the outlet box with ball nuts.
- Place crystal into the frame.
- Install the bulb (not included) in accordance with the fixture’s specifications. Do not exceed the maximum wattage rating.
- Adjust the arms to the desired placement.
How to Install
- Determine the preferred hanging height and choose the correct length of stems needed.
- Slip the wires through the stems and connect them together and place the check ring over the threaded nipple o top of the fixture body.Screw one end of the stem assembly onto the fixture body and the other end onto the swivel on the canopy.
- Attach the mounting plate to the outlet box using box screws and Connect the fixture wires to the supply wires.
- Mount the fixture to the outlet box with ball nuts.
- Place crystal into the frame.
- Install the bulb (Not included) in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING
- Adjust the arms to the desired placement.
Part Number
- A. Mounting Hardware
- (3) – Wire connector
- (1) – Mounting Plate
- (2) – Box Screws
- (1) – Grounding Screw
- B. (2) – Ball Nuts; XVE733MGBANUT
- C. (4) – Crystal; Ø6-3/4″ x H1″
- D. (1) – Canopy; Ø6″ x H1″; XVE734MGCAN6IN
- E. (1) 6″ Stem; XVE734MGSTEM6IN
- F. (3) 12″ Stem; XVE734MGSTEM12IN
- G. (1) – Check ring.
DIMENSION
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>