METROPOLITAN N7819-726 Soho 6-Light Coal and Soft Brass Island Chandelier Instruction Manual
- June 12, 2024
- Metropolitan
Table of Contents
METROPOLITAN N7819-726 Soho 6-Light Coal and Soft Brass Island Chandelier
Instruction Manual
INSTALLATION INSTRUCTIONS
Item#N7819-726 (New. 2022/05/11)
PREPARATION (Fig. 1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting
- Carefully unpack your new fixture and lay out all the parts in a clean Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig. 1)
- Loosen hex nuts (D), take apart metal washer (E), lock washer (L), and swivel (G).
- Determine the desired hanging height and thread rods (F1, F2 and F3) to all thread (S) on fixture body. Carefully pass wires through each rod during Secure swivels (G) onto rods (F1).
- Align canopy (H) and metal plate (I) followed by lock washer (L) and metal washer (E) onto swivels (G) and secure with hex nuts (D) via Wrench (J) (not included).
- Position mounting plate (A) on ceiling and mark location of the two drywall anchors (K). Pre-drill holes for drywall anchors (K). Then insert drywall anchors (K) into
- Attach mounting plate (A) to junction box (Not included) with
mounting screws (B) (Size: #8-32N*L0.5”) and wood screws (O) into drywall anchors (K). The side of the mounting plate marked “GND” must face out.
- The support cable is provided to support weight of fixture while Align fixture to mounting plate (A) and attach hook (P) on end of support cable (R) into a slot located on mounting plate (A). Carefully allow support cable (R) to support the weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
- Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using green screw
- Tuck wire connectors neatly inside the junction
COMPLETING THE INSTALLATION (Fig. 1)
- Align canopy (H) onto mounting plate (A) and secure with screws (C).
- Place glass panel (M) into metal frame (T) and secure with tabs
- Install (6) six candelabra base bulbs (Q) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture — DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>