ferm LIVING ERA Chandelier Lamp Instruction Manual

June 12, 2024
ferm LIVING

ferm LIVING ERA Chandelier Lamp

ferm-LIVING-ERA-Chandelier-Lamp-PRODUCT

Product Information

The ERA CHANDELIER is a contemporary chandelier lamp that adds a touch of elegance to any room. It comes with a lamp base, a long tube, three white opal glasses, and a canopy. The lamp has a voltage of 220-240V, 50Hz and is triax dimmable. It has a DALI dimmable certification, CE certification, IP20 certification, and Class I certification. The socket is an E27 socket, and the recommended light source is three pieces of LED light bulbs with a maximum of 10W.

Product Usage Instructions

  1. Mount the long tube to the lamp base.

  2. Mount the 3x light bulbs, max 10W LED.

  3. Carefully slide the glass opals over the sockets and place them on the metal rings.

  4. Set up the ceiling bracket with appropriate screws and anchors. Screws are not included.

  5. Connect the wire to the junction box; 220-240V to N: Blue wire,
    L: Brown Wire, Ground icon: Green-yellow wire. Make sure that the cable relief is tightened.

  6. Set up the lamp in the ceiling bracket with two screws.

General Instructions

Please read the instructions before installation. The safety of this fitting can only be guaranteed if the instructions are observed during both installation and use. Use only a soft cloth to clean the product. Dampen the cloth with water and soap or a mild cleanser if needed. Please retain these instructions safely after installation.

More Information

To access further information such as product overview and material descriptions, please visit our website at www.fermliving.com. If you have any
questions or comments, please do not hesitate to contact us at info@fermliving.com.

GENERAL INSTRUCTIONS

Please read before installation

WARNING:

The safety of this fitting can only be guaranteed if the following instructions are observed during both installation and use. Please retain these instructions safely after installation.

Please observe the following guidelines:

  • Ensure that the power supply has been switched off prior to installation or removal of the product.
  • Never undertake an electrical installation without the proper knowledge or training. If not familiar with electrical wiring, contact a qualified electrician.
  • The product may in no way be modified or tampered with. Any modification may compromise safety and make the product itself dangerous to use. ferm LIVING does not accept any responsiblility for products that have been modified.
  • This product requires the use of a lightbulb that is not included. Please use a lightbulb that has the relevant safety certifications and approvals for your area.
  • This product is meant for indoor use only.
  • This appliance should not be disposed in a domestic trash receptacle and should instead be recycled appropriately.

CLEANING INSTRUCTIONS:

Use only a soft cloth to clean the product. Dampen the cloth with water and soap or a mild cleanser if needed.
MORE INFORMATION:
To access further information such as product overview and material descriptions, please visit our website at www.fermliving.com if you have any questions or comments, please do not hesitate to contact us at info@fermliving.com

TECHNICAL SPECIFICATIONS

ERA CHANDELIER

  • Voltage: 220-240V, 50Hz
  • Triax dimmable: Yes, if applicable light bulbs are used (not included)
  • DALI Dimmable: No
  • Certification: CE, IP20 Class I
  • Socket: E27
  • Recommended Light source: 3 pieces of LED light bulbs max 10W

BOX CONTENT

ferm-LIVING-ERA-Chandelier-Lamp-FIG-1

NEEDED TOOLS

INSTALLATION INSTRUCTION

  1. Mount the long tube to the lamp base.ferm-LIVING-ERA-Chandelier-Lamp-FIG-3
  2. Mount the 3x light bulbs, max 10W LEDferm-LIVING-ERA-Chandelier-Lamp-FIG-4
  3. Carefully slide the glass opals over the sockets and place them on the metal rings.ferm-LIVING-ERA-Chandelier-Lamp-FIG-5
  4. Set up the ceiling bracket with appropriate screws and anchors. Screws are not included.ferm-LIVING-ERA-Chandelier-Lamp-FIG-6
  5. Connect the wire to the junction box; 220-240V to N: Blue wire, L: Brown Wire, Ground icon: Green-yellow wire. Make sure that the cable relief is tightened.ferm-LIVING-ERA-Chandelier-Lamp-FIG-7
  6. Set up the lamp in the ceiling bracket with two screws.ferm-LIVING-ERA-Chandelier-Lamp-FIG-8

fermliving.com

Documents / Resources

| ferm LIVING ERA Chandelier Lamp [pdf] Instruction Manual
ERA, ERA Chandelier Lamp, Chandelier Lamp, Lamp
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals