PROAIM QR-ELMG-01 Electromagnet Quick Release Mitchell Mount User Manual

PROAIM QR-ELMG-01 Electromagnet Quick Release Mitchell Mount

What’s In The Box

Please inspect the contents of your shipped package to ensure you have received everything that is listed below.

• Mounting Plate (Top Mount & Bottom Mount)

• Wrench

• D-Type Cable

• Battery Plate with Clamp (Front Side & Back Side)

All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means, electronic, mechanical, photo- copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright statutes or in writing by the Publisher.

Hard Case

Electro Magnet Setup

• Loosen castle nut from the top mount.
  

• Now attach it to the airwave (Not Included).
  

• Secure it by tightening the castle nut.
  

• Remove the bottom mounting plate by pulling the button off the mounting plate.
  

• Unlock the connector holder (Not Included) and press the button on the gimbal connector (Not Included).
  

• After unlocking, the gimbal connector (Not Included) and connector holder (Not Included) will look like this.
  

• Mount the Gimbal connector (Not Included) on the bottom mounting plate.
  

• Now secure it using a screw and Allen Key.
  

• Pull the button to attach the bottom mounting plate after flipping it to the top mounting plate.
  

• Use the provided pin to secure the release button.
  
  NOTE: so that whenever your rigs are positioned beneath the magnet, nobody can touch the button release, making it highly secure keeps the gadget in place even when the batteries run out or lose power.

• Unscrew the connector holder (Not Included) to detach the quick-release plate (Not Included).
  

• Now Mount the connector holder (Not Included) on the gimbal (Not Included)
  

• Screw it using the Allen Key.
  

• Now, secure the gimbal (Not Included) to the mounting plate by pushing the connection holder’s buttons and closing the knob.
  

• Release the quick-release plate from Gimbal (Not Included) by unlocking the knob.
  

• Attach the quick-release plate to the camera (Not Included) and secure it with an Allen key (Not Included).
  

• Slide the camera (Not Included) with the plate onto the gimbal (Not Included) and then close the knob.
  

• The Gimbal (Not Included) is now attached.
  

• Now loosen the lever lock to open the clamp of the battery plate.
  

• Mount the battery plate on the airwave (Not Included) and tighten the clamp to secure it.
  

• Connect the D-Type Cable to the battery plate at one end.
  

• Attach the other end of the D-type cable to the mounting plate.

• Slide the battery (Not Included) onto the battery plate.
  

• Turn on the switch on the side of the battery plate.
  

YOUR PROAIM AIRWAVE ULTRA VIBRATION ISOLATOR ARM ALL DRESSED UP AND READY TO GO!

(SHOWN WITH OPTIONAL ACCESSORIES)

Warranty: We offer one year warranty for our products from date of purchase. Within this period of time, we will repair it without charge for labor or parts. Warranty doesn’t cover transportation costs nor does it cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspection and evaluation by us.

Liability: We are not liable for damage caused by products that we do not supply or from mishandling in transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company.

Contact Us: In case of any kind of dissatisfaction, please Contact us immediately and we promise our utmost support and care until you use our product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>