PROAIM VI-ARWV-5 Airwave V5 Camera Vibration Isolator Arm User Manual
- October 30, 2023
- PROAIM
Table of Contents
Airwave V5 Camera Vibration Isolator Arm (VI-ARWV-5)
Assembly Manual
What’s In The Box
Please inspect the contents of your shipped package to ensure you have
received everything that is listed below. 
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or
transmitted by any form or by any means, electronic, mechanical, photo-
copying, recording, or otherwise, except as may be expressly permitted by the
applicable copyright statutes or in writing by the Publisher.
Isolator Arm Setup
- Remove both the bolts of the Airwave V5 Vibration Isolator Arm with the help of an Allen Key.
- Both the bolts of the Airwave V5 Vibration Isolator Arm have been removed, as shown in the image.
Assembling of Dampener
- Properly attach the dampener to the Airwave Vibration Isolator Arm.
- Now insert both bolts into the dampener and properly tighten with the help of an Allen Key.
- Loosen the clamp knob of the dampener and open the clamp.
- Mount the dampener on a Rod (Not Included) and properly tighten the clamp .
NOTE: The arm is equipped with a hydraulic damping support system and shock-absorbing springs that offer you smooth fluid movements.
- Loosen both bolts from the gimbal mounting platform of the Airwave Isolator Arm using an Allen Key, and remove the gimbal mounting platform.
- The gimbal mounting platform has been removed, as shown in the image.
- Now mount the gimbal mounting platform on top of the Airwave Isolator Arm by properly matching the threads.
- Properly tighten both bolts with the help of an Allen Key.
NOTE: The arm clamps directly onto a 38 to 42mm diameter rod or speed rails with a locking clamp, and adjustments are made via a knob at multiple points along the arm’s joints to balance up and down.
Airwave V5 Camera Vibration Isolator Arm Features
NOTE: The valves should always be adjusted evenly and set identically.
Rebound and compression of the hydraulic valves should be set in such a way so
that any loose swinging or vibration of the arm is eliminated.
NOTE: In order to smoothen Dampening effect, turn the adjustment knob. If
the arm is too soft, turn it towards direction of H (Hard). If the arm is
rigid turn it towards the direction of S (Soft). 
Gimabl Setup
- Properly attach DJI RS2 Gimbal (Not Included) to the Isolator Arm.
- Press the push pin and remove the camera plate.
Camera Mounting Setup
- Attach the Camera Plate and Camera (Not Included) together and properly tighten with the help of a screwdriver.
NOTE: It has mounting threads to mount various gimbal or camera mounts,
such as the DJI Ronin 2/S/S2/SC 2, Zhiyun WEEBILL/CRANE.
YOUR PROAIM AIRWAVE V5 CAMERA VIBRATION ISOLATOR ARM ALL DRESSED UP AND
READY TO GO!
Warranty: We offer one year warranty for our products from date of
purchase. Within this period of time, we will repair it without charge for
labor or parts. Warranty doesn’t cover transportation costs nor does it cover
a product subjected to misuse or accidental damage. Warranty repairs are
subjected to inspection and evaluation by us.
Liability: We are not liable for damage caused by products that we do not
supply or from mishandling in transit, accident, misuse, neglect, lack of care
of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissatisfaction, please Contact us
immediately and we promise our utmost support and care until you use our
product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>