Metropolitan N6691-857 Contrast 1 Light Aged Antique Brass and Black Cylinder Mini Pendant User Manual
- October 30, 2023
- Metropolitan
Table of Contents
INSTALLATION INSTRUCTIONS
Item#N6691-857 (New. 9/24/2022)
READ AND SAVE THESE INSTRUCTIONS
N6691-857 Contrast 1 Light Aged Antique Brass and Black Cylinder Mini
Pendant
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION (Fig. 1)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig. 1 & Fig. 2) -
Determine desired hanging height and thread rods (F & G) to metal arm (H). Then thread swivel (L) of canopy (D) onto rod (F). Pass wires carefully through each rod as you assemble.
-
Thread screws (A) into pre-drilled holes in circular strap (B) spaced same distance apart as holes in canopy (D). The length of screws (A) may be adjusted if necessary. Then tighten with washer and hex nut.
-
Attach circular strap (B) to the junction box (Not included) using mounting screws (C) (Size: #8-32N*L1”). The side of circular strap marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect electrical wires as shown in fig. 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to circular strap (B) using green screw provided.
-
Tuck the wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1) -
Raise canopy (D) over circular strap (B) aligning holes on canopy with screws (A) and secure with cap nuts (E).
-
Install (1) one medium base bulbs (J) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification — DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
a. Hardware Bag:
A. Screw 2
B. Circular Strap 1
C. Mounting Screw 2 D. Canopy1
E. Finial *2
b. Hardware Bag:
F. 12” Rod 3
G. 6” Rod 1
LA-3074E
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>