Cattleya 72.75 Inch H Black Solar LED Post Light Instruction Manual

Table of Contents

This product is a solar light with a maximum light output of 600LM.
The model contains 2x 3.7V Li-Ion batteries of type 14500.
The light uses 1 or more LEDs as a light source and contains white SMD-LED (L15).
The sensor angle is 120 degrees, the sensor distance is 7 meters, and the sensor delay time is 15 seconds.

Read the safety and assembly instructions carefully before using the product.
Do not attempt to convert or make any changes to the solar lights yourself as this will void the guarantee. Consult the vendor if in doubt.
Avoid exposing the product to extreme heat, pressure, or other inappropriate use as this will also void the guarantee.
Do not use the product as a toy, and keep it away from children.
To assemble the solar lights, remove the insulation plastic strip and move the switch to ON.
Assemble or place the solar lights without putting any pressure on the solar panel or protection hood. Do not use a hammer.
Place the light carefully in a proper position for good use of the solar sensor. Ensure that it is positioned in a location that receives ample sunlight/daylight so that the battery can fully charge during the day.
Clean the solar cells regularly with water and mild detergent for maximum storage of sunlight.
The light will switch on automatically when it turns dark due to the built-in light sensor.
Do not cover the product with isolation material or any material of that sort.
Recycle the packaging and dispose of batteries in the correct way.

manual in a safe place:**

Read this manual carefully. If in doubt, consult the vendor.
Based on health and safety rules, you must not convert (CE), or make any changes to the solar lights yourself. Should you ignore this the guarantee will be null and void.
Do not expose the product to extreme heat, extreme pressure, or other inappropriate use. Should you ignore this again the guarantee will be null and void.
This product is not a toy and is not used as such by children.

Solar installation instructions:

Remove the insulation plastic strip and move the switch to ON.
Then the batteries need to be fully charged. Place the light in sufficient (sun)light, for one or more days.
Assemble or place the solar lights without putting any pressure on the solar-panel or protection hood. Do not use a hammer!
Because of the built-in light sensor, the light will switch on automatically when it turns dark. Place the light carefully in a proper position, for good use of the solar sensor.
The lamp is provided with a solar cell to charge the battery/batteries. For this, it needs sufficient
sunlight/daylight. Position the lamp with care, so that the battery can fully charge during the day.
Regularly clean the solar cells with water and mild detergent for maximum storage of sunlight.

Technical specifications and guiding lines per model

Take notice of all technical specifications for your product at all times. See the pictorial signs on the enclosed user guide.
Below is an explanation of the pictorial signs.

Cattleya-72.75-Inch-H-Black-Solar-LED-Post-Light-fig-4

P9 This model contains 2x 3,7V Li-Ion battery of the type 14500. This light has a max. 600LM light output
P11 Under normal circumstances the light will burn for 6 hours after turning on power
C7 Solar lighting is designed solely for outdoor use
C1 Safe around children and animals.
C9 No connection to the electrical circuit required
L13 This light uses 1 or more LED as a light source. This combines a long lifetime with low power consumption. Solar LEDs are not interchangeable.
L15 This model contains white SMD-LED.
M2 The product is suitable for placement on/connecting to regularly flammable material/ surfaces. Built-in products must under no circumstances be covered by isolation material or any material of that sort.
M18 Please recycle packaging
M19 Please dispose of batteries in the correct way